Chapter 2 Hardware Installation and Connection
2.4.1.2 DC Power Module (DCP4700-48F)
1Use a screwdriver to loosen the screw on the power slot cover and remove it.
2Grab the handle of the front panel of the power module with one hand and place the other hand under the power module to support it.
3Slide the power module into the slot until it makes contact with the backplane.
4Tighten the screw.
2.4.2 Removing a Power Module
Use the following procedure to remove a power module from the Switch.
2.4.2.1 AC Power Module
1Refer to Section 3.3.4 on page 51 to disconnect the power before you begin.
2Use a screwdriver to loosen the screw on the front panel of the power module.
38 |
| |
| ||
|
|
|