Chapter 4 The Web Configurator
Table 5 Navigation Panel Links (continued)
LINK | DESCRIPTION |
VLAN Mapping | This link takes you to screens where you can configure VLAN mapping |
| settings on the Switch. |
|
|
Layer 2 | This link takes you to a screen where you can configure L2PT (Layer 2 |
Protocol | Protocol Tunneling) settings on the Switch. |
Tunneling |
|
|
|
sFlow | This link takes you to screens where you can configure sFlow settings on |
| the Switch. |
|
|
PPPoE | This link takes you to screens where you can configure how the Switch |
| gives a PPPoE termination server additional subscriber information that |
| the server can use to identify and authenticate a PPPoE client. |
|
|
Errdisable | This link takes you to a screen where you can configure CPU protection |
| and error disable recovery. |
|
|
IP Application |
|
|
|
Static Route | This link takes you to a screen where you can configure static routes. A |
| static route defines how the Switch should forward traffic by configuring |
| the TCP/IP parameters manually. |
|
|
Policy Routing | This link takes you to screens where you can configure policy routing |
| rules. |
|
|
RIP | This link takes you to a screen where you can configure the RIP (Routing |
| Information Protocol) direction and versions. |
|
|
OSPF | This link takes you to screens where you can view the OSPF status and |
| configure OSPF settings. |
|
|
IGMP | This link takes you to a screen where you can configure the IGMP |
| settings. |
|
|
DVMRP | This link takes you to a screen where you can configure the DVMRP |
| (Distance Vector Multicast Routing Protocol) settings. |
|
|
DiffServ | This link takes you to screens where you can enable DiffServ, configure |
| marking rules and set |
|
|
DHCP | This link takes you to screens where you can configure the DHCP |
| settings. |
|
|
VRRP | This link takes you to screens where you can configure redundant virtual |
| router for your network. |
|
|
ARP Learning | This link takes you to a screen where you can configure ARP learning |
| mode on a |
|
|
Load Sharing | This link takes you to a screen where you can enable |
| MultiPath (ECMP) routing and set the criteria the Switch uses to |
| determine the routing path for a packet. |
|
|
Management |
|
|
|
Maintenance | This link takes you to screens where you can perform firmware and |
| configuration file maintenance as well as reboot the system. |
|
|
Access Control | This link takes you to screens where you can change the system login |
| password and configure SNMP and remote management. |
|
|
Diagnostic | This link takes you to screens where you can view system logs and can |
| test port(s). |
|
|
Syslog | This link takes you to screens where you can setup system logs and a |
| system log server. |
|
|
60 |
| |
| ||
|
|
|