Chapter 4 The Web Configurator

4.6.1 Reload the Configuration File

Uploading the factory-default configuration file replaces the current configuration file with the factory-default configuration file. This means that you will lose all previous configurations and the speed of the console port will be reset to the default of 9600bps with 8 data bit, no parity, one stop bit and flow control set to none. The password will also be reset to “1234” and the IP address to 192.168.1.1.

To upload the configuration file, do the following:

1Connect to the console port using a computer with terminal emulation software. See Section 3.2 on page 46 for details.

2Disconnect and reconnect the Switch’s power to begin a session. When you reconnect the Switch’s power, you will see the initial screen.

3When you see the message “Press any key to enter Debug Mode within 3 seconds ...” press any key to enter debug mode.

4Type atlc after the “Enter Debug Mode” message.

5Wait for the “Starting XMODEM upload” message before activating XMODEM upload on your terminal.

6After a configuration file upload, type atgo to restart the Switch.

Figure 27 Resetting the Switch: Via the Console Port

Bootbase Version: V1.00 01/13/2011 19:34:13

RAM: Size = 524288 Kbytes

ZyNOS Version: V4.00(BVG.0)b6 01/28/2011 14:44:24

Press any key to enter debug mode within 3 seconds.

.....................................

Enter Debug Mode ras> atlc

Starting XMODEM upload (CRC mode)....

CCCCCCCCCCCCCCCC

Total 393216 bytes received. Erasing..

................................................................

OK

ras> atgo

The Switch is now reinitialized with a default configuration file including the default password of “1234”.

 

63

XGS4700-48F User’s Guide