Chapter 31 PPPoE
The following table describes the labels in this screen.
Table 103 Advanced Application > PPPoE > Intermediate Agent > VLAN
LABEL | DESCRIPTION |
Show VLAN | Use this section to specify the VLANs you want to configure in the section |
| below. |
|
|
Start VID | Enter the lowest VLAN ID you want to configure in the section below. |
|
|
End VID | Enter the highest VLAN ID you want to configure in the section below. |
|
|
Apply | Click Apply to display the specified range of VLANs in the section below. |
|
|
VID | This field displays the VLAN ID of each VLAN in the range specified above. |
| If you configure the * VLAN, the settings are applied to all VLANs. |
|
|
* | Use this row to make the setting the same for all VLANs. Use this row first |
| and then make adjustments on a |
| Note: Changes in this row are copied to all the VLANs as soon as |
| you make them. |
|
|
Enabled | Select this option to turn on the PPPoE Intermediate Agent on a VLAN. |
|
|
Select this option to make the Circuit ID settings for a specific VLAN take | |
| effect. |
|
|
Select this option to make the Remote ID settings for a specific VLAN take | |
| effect. |
|
|
Apply | Click Apply to save your changes to the Switch’s |
| Switch loses these changes if it is turned off or loses power, so use the |
| Save link on the top navigation panel to save your changes to the non- |
| volatile memory when you are done configuring. |
|
|
Cancel | Click Cancel to begin configuring this screen afresh. |
310 |
| |
| ||
|
|
|