|
| Chapter 36 OSPF |
|
|
|
| Table 119 IP Application > OSPF Configuration > Redistribute (continued) | |
| LABEL | DESCRIPTION |
| Summary | Enter a network IP address which can cover more than one network in |
| address | order to reduce the routing table size. For example, you can use |
|
| 192.168.8.0/22 instead of using 192.168.8.0/24, 192.168.9.0/24, |
|
| 192.168.10.0/24, and 192.168.11.0/24. |
|
| The third octet of these four network IP addresses is 00001000, 00001001, |
|
| 00001010, 00001011 respectively. The first 6 digits (000010) are the |
|
| common part among these IP addresses. So 192.168.8.0/22 can represent |
|
| all of these networks. |
|
|
|
| Subnet | Enter the subnet mask for this summary IP address which can cover |
| mask | multiple networks. |
|
|
|
| Add | Click Add to save your changes to the Switch’s |
|
| Switch loses these changes if it is turned off or loses power, so use the |
|
| Save link on the top navigation panel to save your changes to the non- |
|
| volatile memory when you are done configuring. |
|
|
|
| Cancel | Click Cancel to begin configuring this screen afresh. |
|
|
|
36.6 Configuring OSPF Interfaces
To configure an OSPF interface, first create an IP routing domain in the IP Setup screen (see Section 8.6 on page 113 for more information). Once you create an IP routing domain, an OSPF interface entry is automatically created. See Section 36.1 on page 329 for more information on OSPF.
In the OSPF Configuration screen, click Interface to display the OSPF Interface screen.
Figure 169 IP Application > OSPF Configuration > OSPF Interface
| 339 |
|
|