Oki 5050 manual Installation

Page 24

Installation

Getting Started

To install your new OKIFAX, follow the instructions from Unpacking to Setting the Fax Identification. You must complete these steps for your OKIFAX to operate properly.

If you have purchased an option package for your OKIFAX, refer to the documentation you received with that option for installation instructions.

Where to Install Your OKIFAX

■Place your OKIFAX in a dust-free location away from direct sunlight.

■Allow several inches on each side of the machine to ensure adequate ventilation.

■Make sure that both power and telephone outlets are available nearby.

■Choose a location where the relative humidity is between 20% and 80%, and where the temperature is between 50°F (10°C) and 92°F (32°C).

12Introduction

Unpacking

Before you begin, be sure that all the items listed below are included in your package.

■OKIFAX 5050

■Toner cartridge (wrapped)

■Image drum cartridge (inside machine)

■Power cord

■Telephone line cord

■Document stacker tray

■Quick Start Guide

Refer to the illustrations in the Component Identification chapter.

Note: If any items are missing, contact your dealer immediately. Keep your packing materials and carton in case you ever need to ship or transport the unit.

Installation 12

Of5050hw.pm6

12

4/15/98, 9:26 AM

Image 24

Contents Okifax Okidata Federal Communications Commission Requirements for End Users FCC Telephone Consumer Protection Act OF5050M.PM6 15/98, 923 AM Industry Canada Radio Interference Statement Safety Toner Cartridge Image Drum Unit Handling Direct Access ManuallyContents Faxing Advanced Operations Index Introduction See page 75 for ordering information Component Identification What You Should ReceiveComponents Jack for connecting to an outside telephone line Control Panel Control Panel Keys and Indicators Introduction Introduction One Touch Keypad Signal Tones Installation Take out the image drum cartridge Replace the image drum cartridge Close the document table Okifax Connect Power Loading Paper 3CLOCK Adjustment Setting the Answering Mode 4SYSTEM Data PRG Setting the Language User LanguageConnecting to a PBX Copying To stop the copying process, press the Stop key # OQZ Faxing Dial Directories One Touch Parameters Chain Dialing Programming Groups Faxing Dial Directories Faxing Basic Operations Loading Documents Your documents are now ready for faxing or copying Shortcut Fax Number Programming Receiving Faxes Manually Receiving Faxes in Memory Power Failures and Memory Lift the handset and press the Hook V Request key Faxing Advanced Operations Select a location. Refer to the following instructions Cation Cancel Press the Start key. Your Okifax begins sending the fax 5MAIL Password PRG RX MSG Relay Password Remote List noEnter Waiting to be Polled Polling RX, Select Location Customizing Okifax Customizing Setup FAX Ring Call FAX Number NOW Function noDistinctive RING, SET Not used Changing Your User Function Settings Dial Parameter Settings 2DIAL Parameter Fax Reports Understanding ReportsPrinting Reports Broadcast Confirmation Report MCF Result codes indicate the results of communications Problem Solving Push the buttons on the side of the copy stacker until you Of5050hw.pm6 15/98, 935 AM Printing a Cleaning Lift the document table into an upright position 15/98, 941 AM Change Drum Soon Message Push in the cover release buttons on the side of the copy 0213 FAX No Paper FAX Replace Paper Replace Toner Cart Problem Solving Problem Solving Problem Solving Service and Support Limited Warranty Okidata Service Locations Specifications ITU-T G3Index Auto StartBusy Tone Detect Dial Prefix Incoming Ring ONE Touch Param Printer Alarm Timer ProgRing Response 51 Redial TriesTSI/CSI Material Safety Data Sheet Appearance and odor Black granules, no odor Small Spills

Related manuals

Manual 2 pages 18.4 Kb