Oki 5050 manual Select a location. Refer to the following instructions

Page 53

1 0 Select a location. Refer to the following instructions.

To Select Using	Do This
A One Touch key	Press the One Touch key.
An Auto Dial number	Press the Auto Dial key, then enter the
	two-digit Auto Dial number on the
	numeric keypad.
A number dialed on	Dial as you would on a normal
the numeric keypad	telephone.

1 1 Press the Start key. Your OKIFAX begins waiting for the time and date you have set before feeding the document and sending the fax.

Sending a Delayed Fax From Memory

1Load your documents.

2Press the Select Function key.

3Press the 1/Delayed TX One Touch key. The display shows DELAYED TX and today’s date.

4If the transmission is to occur on the same day, skip to step 6. Otherwise, press the No ▶ key. The display shows PRG. START DATE 0-9.

5Using the numeric keypad, enter the date you wish the transmission to begin—up to three days in advance.

6Press the Yes ◀ key. The display shows PRG. START TIME 0-9.

7Using the numeric keypad, enter the time you wish the transmission to begin, in 24-hour format—8:00 AM is 08:00; 8:00 PM is 20:00.

8Press the Yes ◀ key. The display shows FEEDER TX.

9Press the No ▶ key.

10Select a location. Refer to the instructions below.

To Select Using	Do This
A One Touch key	Press the One Touch key.
An Auto Dial number	Press the Auto Dial key, then enter the
	two-digit Auto Dial number on the
	numeric keypad.
A number dialed on	Dial as you would on a normal telephone.
the numeric keypad
A group	Using the numeric keypad, press the #
	key, then enter the number of the group
	you want to use.

11Press the Yes ◀ key to confirm your selection. The display shows SELECT LOCATION(S).

12Repeat Steps 11 and 12 as often as necessary to continue selecting locations.

13When you are finished selecting locations, press the No ▶ key at the SELECT LOCATION(S) message.

14If you have selected multiple locations, your OKIFAX asks if you want to confirm your selections with a printed report before proceeding. If you do, press the

Faxing: Advanced Operations 41

Of5050hw.pm6

41

4/15/98, 9:32 AM

Image 53

Contents Okifax Okidata Federal Communications Commission Requirements for End Users FCC Telephone Consumer Protection Act OF5050M.PM6 15/98, 923 AM Industry Canada Radio Interference Statement Safety Toner Cartridge Image Drum Unit Handling Manually Direct AccessContents Faxing Advanced Operations Index Introduction See page 75 for ordering information What You Should Receive Component IdentificationComponents Jack for connecting to an outside telephone line Control Panel Control Panel Keys and Indicators Introduction Introduction One Touch Keypad Signal Tones Installation Take out the image drum cartridge Replace the image drum cartridge Close the document table Okifax Connect Power Loading Paper 3CLOCK Adjustment Setting the Answering Mode 4SYSTEM Data PRG User Language Setting the LanguageConnecting to a PBX Copying To stop the copying process, press the Stop key # OQZ Faxing Dial Directories One Touch Parameters Chain Dialing Programming Groups Faxing Dial Directories Faxing Basic Operations Loading Documents Your documents are now ready for faxing or copying Shortcut Fax Number Programming Receiving Faxes Manually Receiving Faxes in Memory Power Failures and Memory Lift the handset and press the Hook V Request key Faxing Advanced Operations Select a location. Refer to the following instructions Cation Cancel Press the Start key. Your Okifax begins sending the fax 5MAIL Password PRG RX MSG Enter Relay PasswordRemote List no Waiting to be Polled Polling RX, Select Location Customizing Okifax Customizing Distinctive RING, SET Setup FAX Ring Call FAX Number NOWFunction no Not used Changing Your User Function Settings Dial Parameter Settings 2DIAL Parameter Understanding Reports Fax ReportsPrinting Reports Broadcast Confirmation Report MCF Result codes indicate the results of communications Problem Solving Push the buttons on the side of the copy stacker until you Of5050hw.pm6 15/98, 935 AM Printing a Cleaning Lift the document table into an upright position 15/98, 941 AM Change Drum Soon Message Push in the cover release buttons on the side of the copy 0213 FAX No Paper FAX Replace Paper Replace Toner Cart Problem Solving Problem Solving Problem Solving Service and Support Limited Warranty Okidata Service Locations ITU-T G3 SpecificationsBusy Tone Detect IndexAuto Start Dial Prefix Incoming Ring ONE Touch Param Timer Prog Printer AlarmRing Response 51 Redial TriesTSI/CSI Material Safety Data Sheet Appearance and odor Black granules, no odor Small Spills

Related manuals

Manual 2 pages 18.4 Kb