Oki 5050 manual Connect Power

Page 29

6Insert the end of the cord into the TEL 1 or TEL 2 jack on the back of the OKIFAX.

Wall jack

Tel 1, Tel 2

Line

Note: The two TEL jacks are provided to allow you to connect both an external handset and an answering machine.

Connecting an External Telephone or Answering Machine

Important Note: Any external telephone or answering machine connected to the OKIFAX must be FCC and CSA approved.

Insert one end of the telephone cord into the TEL 1 or TEL 2 jack on the back of the OKIFAX, and the other end into the jack in your external device.

To connect both an answering machine and a telephone, first connect your answering machine to your OKIFAX, then plug your external telephone’s cord into the telephone jack on your answering machine.

Note: You must have the TAD mode feature turned on for an answering machine to work with your OKIFAX. See Setting the Answering Mode, page 20.

TEL 1

TEL 2

TEL LINE

Jack Jack

Connect Power

1Make sure the power switch is off.

2 Plug the power cord into the back of the unit.

Installation 17

Of5050hw.pm6

17

4/15/98, 9:31 AM

Image 29

Contents Okifax Okidata Federal Communications Commission Requirements for End Users FCC Telephone Consumer Protection Act OF5050M.PM6 15/98, 923 AM Industry Canada Radio Interference Statement Safety Toner Cartridge Image Drum Unit Handling Manually Direct AccessContents Faxing Advanced Operations Index Introduction See page 75 for ordering information What You Should Receive Component IdentificationComponents Jack for connecting to an outside telephone line Control Panel Control Panel Keys and Indicators Introduction Introduction One Touch Keypad Signal Tones Installation Take out the image drum cartridge Replace the image drum cartridge Close the document table Okifax Connect Power Loading Paper 3CLOCK Adjustment Setting the Answering Mode 4SYSTEM Data PRG User Language Setting the LanguageConnecting to a PBX Copying To stop the copying process, press the Stop key # OQZ Faxing Dial Directories One Touch Parameters Chain Dialing Programming Groups Faxing Dial Directories Faxing Basic Operations Loading Documents Your documents are now ready for faxing or copying Shortcut Fax Number Programming Receiving Faxes Manually Receiving Faxes in Memory Power Failures and Memory Lift the handset and press the Hook V Request key Faxing Advanced Operations Select a location. Refer to the following instructions Cation Cancel Press the Start key. Your Okifax begins sending the fax 5MAIL Password PRG RX MSG Enter Relay PasswordRemote List no Waiting to be Polled Polling RX, Select Location Customizing Okifax Customizing Distinctive RING, SET Setup FAX Ring Call FAX Number NOWFunction no Not used Changing Your User Function Settings Dial Parameter Settings 2DIAL Parameter Understanding Reports Fax ReportsPrinting Reports Broadcast Confirmation Report MCF Result codes indicate the results of communications Problem Solving Push the buttons on the side of the copy stacker until you Of5050hw.pm6 15/98, 935 AM Printing a Cleaning Lift the document table into an upright position 15/98, 941 AM Change Drum Soon Message Push in the cover release buttons on the side of the copy 0213 FAX No Paper FAX Replace Paper Replace Toner Cart Problem Solving Problem Solving Problem Solving Service and Support Limited Warranty Okidata Service Locations ITU-T G3 SpecificationsBusy Tone Detect IndexAuto Start Dial Prefix Incoming Ring ONE Touch Param Timer Prog Printer AlarmRing Response 51 Redial TriesTSI/CSI Material Safety Data Sheet Appearance and odor Black granules, no odor Small Spills

Related manuals

Manual 2 pages 18.4 Kb