Note: Occasionally, your OKIFAX may not be able to detect its ring pattern on the first try. If this hap- pens, the display shows RESULT=NG. Follow the in- structions again from Step 6.
8 Press the Yes ◀ key to confirm your selection.
9 Press the Select Function key to finish.
131'ST PAPER SIZE: This function allows you to specify the size of paper you are using in the paper tray. Available settings are LETTER (default), A4, LEGAL 13, and LEGAL 14.
14Not used.
15USER LANGUAGE: This function allows you to switch between the two languages programmed into your OKIFAX. Available settings are ENG. (English, the de- fault) and SPA. (Spanish), FRE. (French), or POR. (Portu- guese), depending on where you purchased your
OKIFAX.
52Customizing
16INCOMING RING: This function controls the tele- phone ringing sound your OKIFAX makes when a call comes in. When set to off, it does not ring dur- ing incoming calls. The available settings are:
■ON (default): Only rings when set to Manual Receive [TEL] mode or when the RING RESPONSE function is set to 5, 10, or 20 seconds.
■OFF: Does not ring when a call comes in.
■DRC (distinctive ring cancel): Rings for each incoming call with the same tone, even if you have set function setting 12, DISCTINCTIVE RING to on.
17REMOTE RECEIVE: This function lets you use an attached phone to tell your OKIFAX to switch from telephone to fax mode so it can receive an incoming fax. Use the keypad of an external telephone to enter the remote receive num- ber you have programmed into your OKIFAX.
In addition, if your OKIFAX is in TAD mode (see page 20), a caller can enter the programmed remote receive number after leaving a voice message; this enables the OKIFAX to receive a fax from the caller.
Available settings are OFF (default), 00, 11, 22, 33, 44, 55, 66, 77, 88, 99, **, and ##.
Of5050hw.pm6 | 52 | 4/15/98, 9:32 AM |