Programming the Remote Control, DVD Codes, Channel

Sanyo DS36930 manual Programming the Remote Control, DVD Codes, Satellite Receiver Codes, Channel

PROGRAMMING THE REMOTE CONTROL

➊Find your VCR, Cable Box, DVD Player, and Satellite Receiver brand codes in the charts at the right and on

page 10.

❷Press and hold the VCR, CABLE, DVD, SAT (Satellite Receiver), or AUX (Auxiliary) mode key

while entering a three-digit code number. Then release the mode key.

If the code was accepted, the mode key will flash				5 times
after it is released. If you entered an invalid code, the mode
key	will not	flash. Check the code number and repeat Step 2.
The	VCR, Cable Box, DVD, and Satellite			modes will
accept only each mode’s specific code type.
The	AUX	mode will accept all code types, but only one code
at a time.
Perform Steps 1 and 2 for each piece of equipment you
have. After entering each code number check the unit’s
operation by pressing the			POWER and/or	CHANNEL

keys. If these keys operate your equipment, you have probably entered the correct code number for that device.

After you have programmed the remote control and con- firmed its operation, enter your codes in the spaces provided below for easy reference.

VCR Code:

Cable Box

Code:

DVD Player

Code:

Satellite Code:

AUX ______________

LIST DEVICE HERE