Sony PCM-R500, PCM-R700 Optional Remote RM-D750, Playing tracks in the order you want RMS* Play

Operations Using the Optional Remote

The Optional Remote RM-D750

You can do the following operations using serial remote control with an optional remote RM-D750 which may be either connected to the REMOTE 2 connector on the rear panel or not. For more information on other remote operations that are possible, refer to the Operating Instructions of the remote.

Note

Set REMOTE on the front panel to WIRED when the remote is connected to the deck. When using it remotely, set REMOTE to WIRELESS.

Checking the track order

You can check the order of tracks in your program by pressing the RMS CHECK button. Each time you press the RMS CHECK button, the track numbers appear in the order they were programmed.

Note

You cannot use the CLEAR button to cancel a programmed track while checking the track order.

To add a track to a program

Repeat steps 1 and 2 while the deck is stopped.

Note

You cannot add a track to a program after RMS Play has started.

Playing tracks in the order you want (RMS* Play)

RMS Play allows you to specify the playback order of the tracks on the tape to create your own programs containing up to 60 tracks (using program numbers 1 to 99). To use RMS Play, however, you must first record start IDs and program numbers on the tape.

To cancel an entire program

Press p repeatedly until “RMS” disappears.

Locating a track by scanning each track (Music Scan)

You can locate a track by scanning the first 8 seconds of each track.

Number buttons

CLEAR

á

OPEN/		COUNTER
CLOSE	MODE RESET

6

START ID

AUTO RENUMBER WRITE REHEARSAL ERASE

LOCATE MARK

1 2 3

4 5 6

RMS

CHECK ENTER

7 8 9

0MARGIN

CLEAR	M.SCAN	REPEAT	RESET
DATE		END ID
RECORDED PRESENT	WRITE	REHEARSAL	ERASE
SKIP		SKIP ID
PLAY	WRITE	REHEARSAL	ERASE

á P p

AMS

=+ R r

INPUT

FADER MONITOR

0 )

RMS

ENTER

RMS CHECK

p

OPEN/		COUNTER
CLOSE	MODE RESET

6

START ID

AUTO RENUMBER WRITE REHEARSAL ERASE

LOCATE MARK

1 2 3

4 5 6

RMS

CHECK ENTER

7 8 9

0MARGIN

CLEAR		M.SCAN	REPEAT	RESET
DATE			END ID	M.SCAN
RECORDED	PRESENT	WRITE	REHEARSAL	ERASE
	SKIP		SKIP ID
	PLAY	WRITE	REHEARSAL	ERASE
á	á		P	p

AMS

=+ R r

INPUT

FADER MONITOR

0)

1Enter the program number (1 to 99) of the track you want to play.

If you‘ve entered the wrong number

Press CLEAR, then enter the correct number.

2Press RMS ENTER.

RMS

ST EP 15

Playing Program order number

3Repeat steps 1 and 2.

4Press á.

The deck starts playing the programmed tracks in sequence.

26EN * RMS = Random Music Sensor

1Press M.SCAN while the deck is stopped.

2Press á.

The deck plays the first 8 seconds of each track in succession.

3When you find the track you want, press M.SCAN.

The track continues playing.

zYou can use Music Scan while playing a track

If you press the M.SCAN button while playing a track, the deck will rewind the tape to its beginning, then play the first 8 seconds of each track on the tape in succession.

3-859-278-11(1)