Sony PCM-R500, PCM-R700 manual Unpacking, Rack Mounting, Inserting batteries into the remote

Getting Started

Unpacking

Check that you have received the following supplied items:

•AC power cord (1)

•Remote commander (remote) RM-D757 (1)

•Size-AA (R6) batteries (2)

•Screws (M5×12) (4)

•Decorative washers (4)

•Operating instructions (1)

Inserting batteries into the remote

Insert two size-AA(R6) batteries, matching the + and – on the batteries with the markings inside the battery compartment.

Rack Mounting

You can install your deck in a 19-inch 3U-size rack. Be sure to disconnect the deck from the wall outlet before you install it.

1Remove the four feet from the deck.

Screw (M3×10)

2Insert the deck into the rack and secure it with the supplied decorative washers and screws (M5×12).

Before using the remote

Set REMOTE on the front panel to WIRELESS.

REMOTE

WIRED OFF WIRELESS

zWhen to replace the batteries

With normal use, batteries should last for about 6 months. When the remote no longer operates the deck, replace both batteries.

Notes

•Do not leave the remote near an extremely hot or humid place.

•Do not drop any foreign matter into the remote casing, particularly when replacing the batteries.

•Do not expose the remote sensor to direct sunlight or illumination as doing so may cause malfunction.

•When not using the remote for an extended period of time, remove the batteries to avoid possible damage from battery leakage and corrosion.

Rack

Screw (M5×12)

Decorative washer

Note

Do not reattach the screws directly after removing the four feet. Put the screws and the feet in a safe place for reattachment in the future. Using longer or shorter screws may damage the internal circuit board.

4EN

3-859-278-12(1)