Checklist …
To ensure the optimum safety of your child, check the following after installation:
•The seat belt is as tight as possible and not twisted.
•The lap part of the seat belt is threaded under the red lap belt marking.
•The (diagonal) shoulder part of the seat belt is secure in the red belt clamp.
•The support leg is fully folded out.
•The indicator at the base of the support leg is completely green.
GB | • In some cases the PrioriFix may not be fully supported by the car seat, but entirely by the support leg. |
| • The entire PrioriFix is installed securely and firmly in the car. |
C. Removing the PrioriFix
22• Restore the support leg to its start position by pressing the control button (22,1) and sliding the support leg upwards (22,2).
•Adjust the shell of the PrioriFix to the sleeping position (see section 4.2: Seat positions).
23• Release the red belt clamp (23).
24• Release the seat belt and remove the seat belt from between the shell and base (24).
•Remove the PrioriFix from the car.
4.PLACING YOUR CHILD IN THE PRIORIFIX
4.1Using the harness system
A. Adjusting the height of the harness
25Before securing your child in the car seat using the harness system, you must first determine the correct height of the shoulder belts for your child (25). Make sure that the shoulder belts fit properly over the shoulders of the child.
26• Loosen the shoulder belts by pressing the release button (26,1) and pulling the shoulder belts towards you as far as possible (26,2).
•IMPORTANT! Do not pull on the belt pads when doing so.
27• Open the belt buckle (27) by pressing the red button on the buckle.
28• Loosen the shoulder belts by pressing the release button and pulling the shoulder belts towards you as far as possible (28).
29• Drape the belts over the hooks on the shell (29).
30• Pull the buckle forwards and pull the buttonhole over the hook (30).
31• Position your child with his or her back upright against the back of the PrioriFix (31).
•Determine the correct height of the shoulder belts for your child.
32• IMPORTANT! The correct height of the shoulder belts is attained when the belt disappears into the shell slightly above your child’s shoulders (32).
•Remove your child from the PrioriFix.
33• To adjust the shoulder belts to the correct height, lift up the flap on the cover by the shoulder belt slots (33).
•Tip: Fold the flap double to keep it in place and place the shell in the sleeping position.
34• To make the adjustment easier, pull the shoulder belts on top of the belt pads forward into a loop, loosening them (34).
•Push the loop back through the opening.
35• Slide the shoulder belt and the belt pad strap through the slot together into the desired position (35).
•IMPORTANT! Always do this on both sides.
36• Pull the shoulder belts tight by pulling on the belts below the belt pads (36).
37• Place the flap back in position and thread the belt pads through the correct slots in the flap (37).
•IMPORTANT! Make sure the belts are not twisted.
English
12