Panasonic WV-CW864 operating instructions Setting the Switches, RS485 Parameter Setup

4. Setting the Switches

The 8-bit DIP switch has two functions. It is used to restore the factory default settings and to specify the unit number. Before set- ting, peel off the seal covering the switch holes. After setting the switch, replace the seal. The 4-bit DIP switch selects termina- tion ON/OFF and half/full duplex for RS485 communication. The switch settings are read into the camera when the power is turned on. After changing the switch set- tings, be sure to turn the power off, then turn it back on again. Switch positions and func- tions are shown below.

RS485 Parameter Setup

The selected protocol, communication para- meters, and set unit numbers are read into the camera when the power is switched on.

(1)Switch off the camera.

(2)Set the switch as shown in the table below.

(3)Set the unit number with the DIP switch (see the next page).

(4)Switch on the camera to read in the changed switch settings.

Note: The changed communication parameters are displayed on the RS485 SETUP menu after the cam- era has been switched on.

Camera top view

REAR

S TA RT

AC24VONLY SWRS485Setting 1

SW2

Seal

							O
							N
						1
						2
					8	3		SW1
					-	4
					bit		5
					DIP		6		SW2
							7
						SW	8
									N		4
									O	3
									2			SW
									1
									-bit		DIP
									4
								Switch view
Switch position								Returns to the factory default settings.
ON
1	2	3	4	5	6	7	8
									Parameter selection
Switch position								Baud rate	Data bit			Parity	Stop
												check	bit
ON								19 200	8			None	1
1	2	3	4	5	6	7	8
ON								9 600	8			None	1
1	2	3	4	5	6	7	8
ON								4 800	8			None	1
1	2	3	4	5	6	7	8
Switch position								Multiplex-Coaxial communication
ON
1	2	3	4	5	6	7	8

51