Adjusting the Sound Characteristics, Tip

	Adjusting the Sound Characteristics
ENGLISH	1. Press the AUDIO	to select the desired adjustment mode
ENGLISH	as follows;
	as follows;
	BASS 0
	TREBLE 0
	LOUD OFF (LOUDNESS)
	X-BASS 0
	L0 R0 (BALANCE)

R0 F0 (FADER)

LE Lo (LEVEL METER)

2. Rotate the VOL dial to adjust the selected item.

Use the following tables as a guide for adjusting the set- tings in each mode.

Adjust within 5 seconds after selecting the item. After 5 seconds, the unit returns to previous indication.

Adjustment Range

BASS	BASS –5		BASS 5

TREBLE	TREBLE –5		TREBLE 5

LOUDNESS	LOUD OFF		LOUD ON

X-BASS	X-BASS 0		X-BASS 4

BALANCE	L9 R0(Full left)		L0 R9(Full right)

FADER	R9 F0(Full rear)		R0 F9(Full front)

LEVEL METER	OFF	Lo (Normal)		Hi (High)

Tip

Settings for BASS, TREBLE, LOUDNESS and XBASS can be made to each of the following modes independently:

FM, AM, CD, CD Changer and AUX.

E-4

Enhancing the bass sound

For extended bass centered @ 72Hz, Blaupunkt’s X-BASS function can be set for either each band and CD mode.

You can select :

•X-BASS 1 : Enhanced BASS level (low).

•X-BASS 2 : Enhanced BASS level (Middle).

•X-BASS 3 : Enhanced BASS level (High).

•X-BASS 4 : Enhanced BASS level (Very high).

•X-BASS 0 : No BASS enhanced.

Press the AUDIO to display the “ X-BASS ” on the display win- dow. Each time you rotate the VOL dial, the current mode appears on the display window and the mode change as fol- lows:

X-BASS 0 (No display)

X-BASS 1

X-BASS 2

X-BASS 3

X-BASS 4

Note

Reduce XBASS level if your combination of speakers and add- on amplifiers sound distorted at the preferred sound level.

Level Meter Sensitivity selection

The sensitivity of the level meter display can be switched.

You can select :

•OFF (No indication)

• Low	: Normal (Low) sensitivity.
• High	: High sensitivity.

1. Press the AUDIO to display the “ LE Lo ” on the display window.

2. Rotate the VOL dial to select the desired meter sensitiv-

ity.

:OFF

: Lo

:Hi

Switching the Source (Selecting auxiliary input)

You can connect auxiliary equipment (Portable cassette player, etc) to this radio via optional AUX-IN cable. (See page 9)

Each time the	CD	is pressed, the operation source will

change over as shown below;
RADIO CD		CD changer or AUX

Press the BAND to return to tuner mode.

Note

If the	CD	button is pressed when no CD has been loaded

into the unit, The CD mode will skip to the CD changer mode or AUX mode.

Also, if the CD changer is not connected, the system will move across to the AUX mode regardless of whether auxiliary equip- ment is connected or not (“ AU ” will be displayed.)

It is not possible to switch to the AUX mode when the CD changer is connected.

BPV660(EN)_body

1/22/02, 10:48 AM