PausingorRestarting
1.To pause the washer at any time, select PAUSE/CANCEL.
2.To continue the cycle, select HOLD TO START (for approximately 1 second).
ChangingCycles,Options andModifiers
Not all Options and Modifiers are available with all cycles. Cycles, Options and Modifiers can be changed anytime before HOLD TO START is selected.
Options and Modifiers can be changed anytime after HOLD TO START is selected and before the start of the selected Option or Modifier.
To cancel a cycle and select a new cycle
1.Select PAUSE/CANCEL twice.
2.Select desired cycle.
3.Select the desired OPTIONS or MODIFIERS.
4.Select HOLD TO START (for approximately 1 second) to restart the washer at the beginning of the new cycle.
To cancel a cycle
1.Select PAUSE/CANCEL twice.
2.The washer powers down, the door unlocks, and clothes can be removed.
NOTE: If the water level or the temperature is too high, the washer will drain automatically before the door unlocks.
To change Options or Modifiers after the cycle has started
1.Select PAUSE/CANCEL.
2.Select the desired OPTIONS or MODIFIERS.
3.Select HOLD TO START (for approximately 1 second) to continue the cycle.
To drain the washer manually
1.Select PAUSE/CANCEL.
2.Select DRAIN/SPIN.
3.Select HOLD TO START (for approximately 1 second) to begin the drain.
4.When the spin is complete, the door unlocks. Items can be removed from the washer.
StatusLights
These lights show which portion of the cycle the washer is operating. They also indicate when you can add an additional item to the wash cycle and when the controls are locked.
Adding items
This washer allows an
To add items
1.Select PAUSE/CANCEL. The washer door unlocks, and items can be added.
2.To continue the cycle, close the door and select HOLD TO START (for approximately 1 second).
3.To unlock the door after the Add a Garment period, press PAUSE/CANCEL twice. This will cancel the Wash Cycle.
Cycle Complete
The cycle complete light stays on for 5 minutes after the cycle is complete, and then the washer shuts off.
Locking controls
The Control Lock prevents unintended use of the washer. You can also use the control lock feature to prevent unintended cycle or option changes during a cycle. When CONTROL LOCKED is lit, all buttons are disabled except for PAUSE/CANCEL and START. You can lock the controls while the washer is operating.
To lock the controls
Select and hold END OF CYCLE SIGNAL for 3 seconds.
The CONTROL LOCKED status light glows.
To unlock the controls
Select and hold END OF CYCLE SIGNAL for 3 seconds until the CONTROL LOCKED Status light turns off.
Door Locked
When the status light glows, the door is locked.
Estimated time remaining
The cycle times vary automatically based on your water pressure, water temperature, detergent, and clothes load. The cycle time will be extended if oversudsing occurs or the load is unbalanced. The SUDs routine removes extra suds and assures proper rinsing of your garments. During the unbalance routine the time displayed may pause until this activity is complete, then resume with the remainder of the cycle.
13