AKG Acoustics PT 4500 manual Operate after approx seconds, Mute switch is active in all modes

Page 23

2 Description

-approximately 60 minutes before the batteries or BP 4000 battery pack wil be dead; and

-while the transmitter recalls the carrier frequency from memory after you turned power to the transmitter on. Unless you muted the audio signal, the status LED will change to green as soon as the frequency has been recalled.

-while the display shows an error message.

Dark: The transmitter is in SILENT mode.

2Display: The transmitter provides a five-line display:

Alphanumeric display of the currently active value or battery capacity in hours

Battery capacity or audio level bar graph

Preset Name, Frequency Group, Channel (Preset menu only)

Operating condition, measurement unit

Parameter to be adjusted

The display indicates all transmitter parameters:

-Carrier frequency in MHz or as a Channel of a Frequency Group

-Audio input level

-Battery status and remaining operating time

-Error messages

-Setup menus: Frequency, Preset, Gain

The backlighting of the display comes on every time you actuate the setup switch and will switch off after approximately 10 seconds.

3 ON/OFF button: A short push (approx. 0.6 seconds) will switch power to the transmit-

Refer to fig. 1.

ter ON and activate the display (2) and status LED (1). The transmitter will be ready to

 

operate after approx. 7 seconds.

 

A long push (approx. 2 seconds) will switch power to the transmitter OFF.

 

The ON/OFF button is recessed for protection from unintentional actuation.

 

4MUTE switch: Sliding the MUTE switch toward the outside of the transmitter (arrow) will mute the audio signal. The status LED (1) will change to red. Since power and the RF section remain ON, no unwanted noise will become audible from the sound system when you mute the audio signal.

To switch the audio signal back on, slide the MUTE switch toward the inside of the trans- mitter (toward the ON/OFF switch). The status LED (1) will change to green.

The MUTE switch is active in all modes.

5Audio input: 3-pin mini XLR connector with both mic and line level pins that automat- ically match the connector pinout of the recommended AKG microphones or optional MKG L instrument cable.

6Setup switch: Sets the various parameters of the transmitter. The setup switch has the following functions:

•LOCK mode:

Turn left or right briefly to scroll between Frequency, Preset (only if a Preset has been loaded), Gain, and Battery Capacity (shown in hours) screens.

Long push: toggles between LOCK and ACTIVE modes when the transmitter is ON. When power to the transmitter is OFF, a long push switches the transmitter ON and places it in SILENT mode.

PT 4500

23

Page 22 Page 24
Image 23
Page 22 Page 24
Contents D I E N U N G S a N L E I T U N G . . S Inhaltsverzeichnis Sicherheit und Umwelt Beschreibung Angeordnet Nur im Preset-MenüRot In folgenden Fällen leuchtet die Kontroll-LED rot Des Senders aus516 ML, C 518 ML, C 519 ML CK 55 L, C 417 L, C 520 L, C 555 LHinweis Wichtig Setup-Schalter kurz drücken Setup-Schalter lang drückenSetup-Schalter kurz nach rechts oder links drehen InbetriebnahmeZu stören Keit siehe Kapitel 3.8 einstellenInbetriebnahme Schalter Tan eingestellten Presets beginnen zu blinkenWenn kein Preset gespeichert ist, zeigt das Display Bei Ihrer lokalen Regulierungsbehörde erfahrenSiehe Kapitel Frequenz-Menü Selben Frequenzgruppe auszuwählen Quenz abgestimmtMehrkanalanlagen Quenz einzustellenManuelle Einstellung Inbetriebnahme Betriebshinweise Freien Kanal der gewählten Frequenzgruppe MUTE. Die Kontroll-LED 1 wechselt auf rotLung ON. Die Kontroll-LED 1 wechselt auf grün Achten Sie darauf, das Mikrofon auf den Mund auszurichtenReinigung Fehlermeldungen Technische Daten FehlermeldungenTable of Contents Environment Safety and EnvironmentSafety Chanical vibrations, or shockDescription Operate after approx seconds Mute switch is active in all modesActive and Silent modes only Close the battery compartment door Symbols Connecting Turn the setup switch briefly to the left or rightOpen the battery compartment door Frequency refer to .6 and input gain refer to section Setting UpSetting Up Setting Up Lock mode, referring to section Press Setup briefly. The display will change like thisQuency for each transmiter and receiver Push the setup switch brieflyAs follows UsingOperating Notes Head-worn microphones Teries or BP 4000 battery pack from the transmitterBelow the frequency readout PossibleCleaning Error Messages Est AKG Service Center Error MessagesPower to transmitter on 760 790, 790 820, 835 862 MHz Carrier frequency rangesSommaire Sécurité et environnement Description Émetteur de poche Piles 1,5 Dimension AADe commande Teur Voir Fig Introduction Fournitures d’origineTion de la touche ON/OFF. La LED témoin 1 passe au vert Cepteur lorsque le signal audio est sur muetTension ON/OFF est en retraitDu câble guitare MKG L d’AKG En mode LockCâble guitare Tourner la molette d’un geste bref à droite ou à gauche Mise en serviceAppuyer brièvement sur la molette ’entrée voir point ModesInadvertance des paramètres en cours d’émission Si l’émetteur est sous tension, mettez-le hors tension Voir Fig Sélection de la porteuse Menu PresetsAppuyez 0,6 seconde environ sur la touche ON/OFF Nez la molette à gauche Si aucun preset n’est mémorisé, l’écran afficheSe mettent à clignoter Nez la molette à droiteVoir point Menu Fréquences Mise en serviceSecondes environ. L’écran affiche Du gain d’entrée Mise en service Menu Gain Gain d’entrée en dB Modes SetupSélection du mode UtilisationSie 520 L, C 555 L Modes d’emploi respectifs Installations’emploi du microphone MulticanauxNettoyage Messages d’erreur Caractéristiques techniques Messages d’erreurIndice Sicurezza Ambiente Sicurezza e ambienteDescrizione Dopo ca secondi il trasmettitore è pronto all’esercizio Della batteria in oreParametro da regolare Il display visualizza tutti i parametri del trasmettitoreChitarra non in dotazione Messa in esercizio Frequenza portante attualmente prescelta in MHz Splay 2 si attivaPortante Premete il tasto ON/OFF 3 per circa 0,6 secondiIndicazione Vedi fig DisattivazioneDi frequenze è sono ammessoi nel vostro paese Setup a destraTore Setup a sinistra SetupMessa in esercizio Nuovo una frequenza per ogni trasmettitore e ricevitore SceltoSinistra o a destra. Sul display viene visualizzato Save -n Messa in esercizio Indicazioni per l’esercizio Prossimo canale libero del gruppo di frequenze prescelto Pulizia Indicazioni errori Gamme delle frequenze portanti Errori visualizzati sul display Errore Rimedio Err.JoGSinserire il trasmettitore e Reinserirlo dopo 10 secondiÍndice Medio ambiente Seguridad y medio ambienteSeguridad Braciones o a golpesDescripción Cio De la pila en horasDad de medición Parámetro a ajustarDescripción Puesta en funcionamiento Sualizador 2 se encienda ModosBilidad de entrada véase capítulo Mentos de mando están activadosAviso oFF Todos los modos Puesta en funcionamientoEn verde DesconectarQuierda Tador Setup hacia la derechaSet seleccionado actualmente empiezan a parpadear RechaVéase capítulo 2 Menú de frecuencia Ruidos de interferencia Cuencias seleccionadoMente la frecuencia para cada transmisor y receptor Selección manual Selección automática Puesta en funcionamiento Instrucciones para el uso Oriente el micrófono hacia la boca del usuario MUTE. El LED de control 1 cambia a rojoON. El LED de control 1 cambia a verde Tado el micrófonoLimpieza Avisos de error Datos técnicos 103 100101 102Segurança Meio ambiente Segurança e meio ambienteDescrição Voluntário Segundos516 ML, C 518 ML, C 519 ML Operação Importante Ligar OperaçãoDesligar Pressione por ca ,6 segundos a tecla ON/OFFLigar no modo Lock Veja fig Mute não aparece e o LED de controle 1 brilha verdeSetup para a esquerda Se nenhum preset for armazenado o display mostraTrole Setup Setup para a direitaVeja capítulo Menu de freqüências 101 Cia novamente para cada emissor e receptor LecionadoAjuste manual Ajuste automático 103 104 Comutar entre os Instruções para o usoDe ajuste Modos ActiveDo grupo selecionado de freqüências Cia entre o microfone e a bocaDê atenção a orientar o microfone para a boca do usuário 520 L, C 555 L Do respectivo microfoneLimpeza Indicações de falha Especificações Indicações de falhaNotizen Notes Notes Note Notas Notas 111 Page
Top Page Image Contents