Make Gas Connection
Gas Connection to a 20 lb LP Gas Fuel Tank
WARNING
Explosion Hazard
Use a new CSA International approved “outdoor” gas supply line.
Securely tighten all gas connections.
If connected to LP, have a qualified person make sure gas pressure does not exceed 11” (28 cm) water column.
Examples of a qualified person include:
licensed heating personnel,
authorized gas company personnel, and authorized service personnel.
Failure to do so can result in death, explosion, or fire.
If converting to local LP or Natural gas, follow the instructions in the “Gas Conversions” section.
IMPORTANT: A 20 lb LP gas fuel tank must be purchased separately.
IMPORTANT: The gas pressure regulator/hose assembly supplied with the grill must be used. Replacement gas pressure regulator/hose assembly specific to your model, is available from your outdoor grill dealer.
To Install the 20 lb LP Gas Fuel Tank:
1.Open cabinet doors.
2.Pull out the tank tray.
Tank tray
3.Place the 20 lb LP gas fuel tank bottom collar into the mounting hole in the tank tray.
4.Tighten the locking screw against the bottom collar of the 20 lb LP gas fuel tank to secure.
A 
BC
A.Locking screw
B.Mounting hole
C.Bottom collar
5.Screw the gas pressure regulator/hose assembly to the 20 lb LP gas fuel tank as shown. (To disconnect, turn off the gas supply to the 20 lb LP gas fuel tank, then unscrew the gas pressure regulator/hose assembly from the 20 lb LP gas fuel tank as shown.)
connect
disconnectB
A
A. 20 lb LP gas fuel tank
B. Gas pressure regulator/hose assembly
6.Turn on the gas supply. Wait a few minutes for gas to move through the gas line.
7.Test all connections by brushing on an approved noncorrosive
8.Slide tank tray back into the cabinet.
9.The batteries are not factory installed. The
10.Go to “Plug in Grill” in this section.
16