6.If flame is yellow (not enough air), turn air shutter adjustment screw counterclockwise.
If flame is noisy or lifts away from burner (too much air), turn air shutter adjustment screw clockwise.
A
A. Air shutter adjustment screw
Adjustment should be made clockwise or counterclockwise from ¹⁄₈" (3.2 mm) to ¹⁄₄" (6.4 mm).
7.Replace gas burner, sear plates and grates.
8.Light grill using information in the “Outdoor Grill Use” section. See “Burner Flame Characteristics.”
Low Flame Adjustment
If flame goes out on the “LO” setting, the low flame setting must be adjusted.
1.Turn off the valve and wait until grill and burners are cool.
2.Remove grill grates and sear plates.
3.Light grill using information in the “Outdoor Grill Use” section.
4.Turn burner to its lowest setting and remove knob.
5.Hold valve stem with pliers and insert a small
6.Watch the flame and slowly turn the screwdriver counterclockwise.
7.Adjust flame to minimum stable flame.
A
B
C
A. Valve stem
B.Small
C.Pliers
8. Replace the control knob and turn off the burner.
9. Repeat steps 3 through 8 for each burner if needed.
10. Replace the sear plates and grates after the burners have cooled.
OUTDOOR GRILL USE
This manual covers several different models. The grill you have purchased may have some or all of the features listed. The locations and appearances of the features shown here may not match those of your model.
Control Panel
ABCDEFG
A. Left rotisserie burner control knob B. Left grill burner control knob
C. Center grill burner control knob
D. Right grill burner control knob | F. Sear burner control knob |
E. Electronic grill display (on some models) | G. Right rotisserie burner control knob |
Light switch button (on some models) |
|
23