KitchenAid KBNS271TSS, W10175730A, KBNU271VSS, KBNU367TSS, KBNU361VSS Cabinet Cutout Dimensions

Cabinet Cutout Dimensions

Enclosure and clearance dimensions that are shown must be used. Given dimensions provide required clearances.

The installation of this grill must conform with local codes or, in the absence of local codes, with either the National Fuel Gas Code, ANSI Z223.1/NPFA 54, Natural Gas and Propane Installation Code, CSA B149.1, or Propane Storage and Handling Code, B149.2.

Copies of the standards listed may be obtained from:

CSA International

8501 East Pleasant Valley Rd.

Cleveland, Ohio 44131-5575

NOTE: The grill drops into the opening and is supported by its side flanges. Do not use a bottom support.

The dimension chart and illustration below include cutout dimensions and minimum spacing requirements for all built-in outdoor products. The illustration is for reference. The design of your cabinet layout can be personalized, but the dimensions for the cutouts and minimum spacing must be followed.

C

C

				.
			.5 cm)	min
12"
			accessory
		(30
to	any

			.
	.6 cm)		min
3"	(7	hood
	open
to

	E
	.
12"	min
any
to
accessory
D

E

K

				Warming
		"		Drawer
	¹⁄₈
9
.2 cm)
(23
			K		J
			.
	5"
			min
.7	cm)
(12

B

				Grills		or				Centers
Side				Refreshment
		D
or
Sear
Burners
						Access				Doors
				.0 cm)
Utility			"	(53
		⁷⁄₈
or	20
Trash
Drawer											L
										min	.
					"		(6	.4	cm)
				2¹⁄₂

K

KF

M

											A
			1¹⁄₂		"	min			.	H
	(3	.8	cm)
		.4 cm)
	" (52
⁵⁄₈
20
	Refrige						rato	r
	or			Maker
	Ice

K

G

Minimum Spacing Requirement Between Cutouts - Dimension K

Between 2 or more sets of Access Doors adjacent to each other:

K = 14" (35.6 cm) when 2 adjacent doors are opened to 90 degrees

K = 8" (20.3 cm) when 1 of the adjacent doors is opened to 90 degrees

Between a set of Access Doors and a Trash Drawer, Utility Drawer, Warming Drawer, Refrigerator, or Ice Maker:

K = 8" (20.3 cm) when 1 of the adjacent doors is opened to 90 degrees

Between a Trash Drawer, Utility Drawer, or Warming Drawer:

K = 3" (7.6 cm)

7