A&D AD-4405 manual Functions, Changing the Function Settings

ESC key

CLEAR key

6. Functions

There are two parameters lists, one for the F-functions and one for the CF-functions. These functions control the indicator. The parameters of each function are stored in non-volatile memory, and are not lost even if power is turned off or cut off.

F-functions: These parameters can always be changed and are used for internal settings.

CF-functions: If you accept a certificated approval of the weighing instruments, the CAL cover (rear panel) must be sealed. Therefore, accepting this approval, the parameters of the CF-function can not be changed.

6.1. Changing the Function Settings

To enter the function settings, do either of the following.

1.When the display is off, press the ON/OFF key while pressing the +/- key.

2.When in the weighing mode, press both the +/- and ON/OFF keys at the same time.

When you are in the function setting, f00 will be displayed.
Operating Item
Step 1 Select an item using the 0 - 9 keys.		Weighing
ENTER key	The key to display a parameter of
	the selected item.	NET/GROSS	PRINT	NET/GROSS	PRINT
	Proceed to step 2.	+/-	ENTER	+/-	ENTER
ESC key	To end function setting and enter
	the weighing mode.
CAL key	The key to exchange F-functions
	and CF-functions.

Operating parameter

Step 2 Select a parameter using the 0 - 9 keys. ENTER key The key to store a parameter

and return to step 1.

The key to return step 1 without changing the parameter.

Change the display as default value.(Type1)

Change sub item.(Type2, Type3)

0 9

PRINT

ENTER

0 9

PRINT

ENTER	PRINT
	ENTER

TARE

Type2 and Type3 are indicated in the

parameter table.

ESC

Weighing

Exit function setting

Press ESC key to go to the weight display when item number is displayed.

6. Functions Page 22 AD-4405 Weighing Indicator