HH | MM | SS | ## | ! |
|
|
|
|
ON OFF
MM : SS HH : MM
CP 1
CP 2 | C | 1 2 3 |
CP 3 | P |
|
FIG. 32
Run Mode
Backup Time
•In both Cycle and Pressure modes a Backup Time (maximum run time) has been set.
•The LED(s) next to all programmed sensors (C/P1, C/P2, C/P3) illuminate.
•The display shows time remaining until a fault.
The example shown in FIG. 33 shows 14 min- utes and 33 seconds left until the fault occurs.
•If all cycle and/or pressure requirements are met the unit exits the lubrication cycle (Pump ON) and enter the rest cycle (Pump OFF).
HH | MM | SS | ## | ! |
|
|
|
|
ON OFF
MM : SS HH : MM
CP 1
CP 2 | C | 1 2 3 |
CP 3 | P |
|
FIG. 33
Rest Mode (Pump OFF) Controls
In Max models the Rest Mode (Pump OFF) is controlled by machine counts.
If the Machine Count is set to a value greater than 0000 and the Backup Time option is activated, the display will alternate between Machine Counts and Backup Time.
If Machine Count has been set to a value greater than 0000 and the Backup Time option is NOT activated, the display will only show the number of Machines Counts remaining.
332305B | 53 |