Run Mode
Time Control
After setup is complete, the G3 automatically begins to run the OFF Time sequence (FIG. 28).
•The G3 runs the programmed OFF sequence.
(Notice the OFF Time LED on the display lights and the OFF Time counts down on the display.)
•The example shown in FIG. 28 shows an OFF Time of 1 hour and 32 minutes before the lubrication cycle begins.
HH | MM | SS | ## | ! |
|
|
|
|
ON OFF
MM : SS HH : MM
CP 1
CP 2 | C | 1 2 3 |
CP 3 | P |
|
FIG. 28
Run Mode
•When the OFF Time count reaches zero, the G3 Automatic Lubrication Pump turns the pump on and it runs for the programmed ON Time cycle (FIG. 29).
(Notice the ON Time LED is now illuminated on the display.)
•The example shown in FIG. 29 shows an ON Time of 8 minutes and 42 seconds before the lubrication cycle ends.
HH | MM | SS | ## | ! |
|
|
|
|
ON OFF
MM : SS HH : MM
CP 1
CP 2 | C | 1 2 3 |
CP 3 | P |
|
FIG. 29
•When the ON Time count reaches zero, the pump shuts off again and the system again runs OFF Time cycle and the OFF Time LED is now again illu- minated (FIG. 28).
This sequence repeats itself until the device is reprogrammed or an alarm occurs.
•If power to the pump is lost during a lubrication cycle, when power is restored the pump will resume the cycle with the same amount of time remaining in the cycle as when the power was lost.
332305B | 51 |