Figure 1A TYPICAL MOUNTING SCHEME
Figure 2A MODIFIED MOUNTING SCHEME
SUPPLY AIR
RETURN AIR
10 - 24 SCREW
10 - 24 FLAT NUT⅜" SLOPE DOWN
CONDENSER
AIR OUTLET
CONDENSER
AIR INLETS
#12A x 2" SHEET METAL SCREW
1" x 4" OR 2" x 4" SPACER BETWEEN WALL AND BRACKET SHOULD BE USED ON ALUMINUM, ASBESTOS OR VINYL SIDING.
CUT
HERE
DISCARD SHADED AREA
⅜" SLOPE DOWN
DIMENSION "A"
STONE LEDGE
OUTSIDE WALL
CUT TO FIT DIMENSION "A" AND BEND DOWN TO FORM A VERTICAL LEG.
Figure 3A TYPICAL MOUNTING SCHEME
STONE LEDGE | ⅜" SLOPE | |
DOWN | ||
|
#12 x 2" SHEET METAL SCREW
2" x 4" SPACER
Figure 4A REVERSE SUPPORT BRACKET SCHEME
STONE LEDGE
⅜" SLOPE DOWN
STRAIGHTEN TAB TO LAY FLAT
ALONG THE BOTTOM RAIL OF
THE SHELL
SECURE THE LONGEST SIDE OF
THE BRACKET TO THE SHELL
ADJUST IN OR OUT TO REST
ON LEDGE
STEP 9 CUT WINGBOARD PANELS – Measure and cut the wingboard panels from the Masonite supplied (Item #8) to fit the spaces be- tween the side window channels and the sides of the cabinet. (See Figure E).
NOTE: AFTER CUTTING THE PANELS, MAKE A TRIAL TEST TO SEE IF THEY FIT THE SPACE WITH ABOUT 1⁄8" CLEARANCE BEFORE GOING TO STEP 10.
STEP 10 ASSEMBLE THE CLIPS TO THE WINGBOARD PANELS- Assemble the "J" type speed nuts (Item 9) and spring steel clips (Item 10) to the edges of the cut wingboard panels (See Figure F).
Figure F | "J" TYPE SPEED NUT |
| (ITEM #9) 2 REQUIRED |
CUT
WINGBOARD
PANEL
CENTER THE HOLE IN THE
SPEED NUT OVER THE SLOT IN
THE WINGBOARD PANEL
SPRING STEEL
CLIP (ITEM #10) 2
REQUIRED
3"
CUT EDGE
3"
SLIDE CLIP OVER
CUT EDGE OF
WINGBOARD
PANEL
12