Drain Valve: The drain valve is located at the base of the air tank and is used to drain condensation at the end of each use.
Check Valve: When the air compressor is operating, the check valve is "open", allowing compressed air to enter
the air tank. When the air compressor reaches
Pressure Release Valve: The pressure release valve located on the side of the pressure switch, is designed to automatically release compressed air from the compressor head and the outlet tube when the air compressor reaches
Pressure
Release
Valve
Check
Valve
Motor Overload Protector (not shown): The motor
has an automatic reset thermal overload protector. If the motor overheats for any reason, the overload protector will shut off the motor. The motor must be allowed to cool down before restarting. The compressor will automatically restart after the motor cools.
Air Intake Filter (not shown): This filter is designed to clean air coming into the pump. This filter must always be clean and ventilation openings free from obstruc- tions. See Maintenance.
How to Use Your Unit
How to Stop
Set the Auto/Off switch to "Off".
Before Starting
Do not operate this unit until you read this instruction manual for safety, operation and maintenance instructions.
Before Each Start-Up
1.Set the Auto/Off switch to "Off".
2.Plug the power cord into the correct branch circuit receptacle. (Refer to Voltage and Circuit Protection paragraph in the Installation section of this manual.)
3.Pull the regulator knob out and turn counterclockwise to set the outlet pressure to zero.
4.Attach hose and accessories.
Risk of unsafe operation. Firmly grasp air hose in hand when installing or disconnecting to prevent hose whip.
Risk of unsafe operation. Do not use damaged or worn accessories.
NOTE: The hose or accessory will require a quick connect plug if the air outlet is equipped with a quick connect socket.
12- ENG