Porter-Cable C6110 instruction manual Troubleshooting, Replacement Parts Service and Repairs

REPLACEMENT PARTS SERVICE

REPLACEMENT PARTS

Use only identical replacement parts. For a parts list or to order parts, visit our service website at www.deltaportercableservicenet.com. You can also order parts from your nearest PORTER-CABLE Factory Service Center or PORTER-CABLE Authorized Warranty Service Center. Or, you can call our Customer Care Center at 1-(888)-848-5175.

SERVICE AND REPAIRS

All quality tools will eventually require servicing and/or replacement of parts. For infor- mation about PORTER-CABLE, its factory service centers or authorized warranty ser- vice centers, visit our website at www.deltaportercable.com or call our Customer Care Center at 1-(888)-848-5175. All repairs made by our service centers are fully guaranteed against defective material and workmanship. We cannot guarantee repairs made or attempted by others.

You can also write to us for information at PORTER-CABLE, 4825 Highway 45 North, Jackson, Tennessee 38305 - Attention: Product Service. Be sure to include all of the information shown on the nameplate of your tool (model number, type, serial number, etc.).

ACCESSORIES

Since accessories, other than those offered by PORTER-CABLE, have not been tested with this product, use of such accessories with this tool could be haz- ardous. To reduce the risk of injury, only PORTER-CABLE recommended accessories should be used with this product.

A complete line of accessories is available from your PORTER-CABLE Factory Service Center or a PORTER-CABLE Authorized Warranty Service Center. Please visit our Web Site www.deltaportercable.com for a catalog or for the name of your nearest supplier.

TROUBLESHOOTING

Risk of Unsafe Operation. Unit cycles automatically when power is on. When servicing, you may be exposed to voltage sources, compressed air, or moving parts. Before servicing unit unplug or disconnect electrical supply to the air compressor, bleed tank of pressure, and allow the air compressor to cool.

PROBLEM	CAUSE	CORRECTION
Excessive	Pressure switch does	Move Auto/Off lever to the "Off"
tank pressure	not shut off motor when	position, if the unit does not shut off
- safety valve	compressor reaches	contact a Trained Service Technician.
pops off	"cut-out" pressure.
	Pressure switch "cut-	Contact a Trained Service Technician.
	out" too high.
Air leaks at	Tube fittings are not	Tighten fittings where air can be
fittings	tight enough.	heard escaping. Check fittings
		with soapy water solution. DO
		NOT OVER TIGHTEN.

17-­ ENG