DeWalt DS200, DS100 If Master Codes Do Not Match, Step Four Assign Devices, List of Devices Code

English

4.If the master codes match, the screen will indicate that the master code has been saved. Select NEXT.

NOTE: If the codes do not match, the screen will display Code Incorrect.

If Master Codes Do Not Match

1.Select OK.

2.Re-enter the master code. Select OK.

3.If the codes match, the screen will indicate that the master code has been saved. Select NEXT.

STEP FOUR: ASSIGN DEVICES

Up to 48 sensors and 6 Key Chain Remotes can be assigned. As each sensor is added, it will communicate with the Base Unit to notify the user of an intrusion. Additional sensors and remotes can be programmed at any time after the initial setup. Refer to Wireless Device Maintenance.

NOTE: Each device (Key Chain Remote or sensors) must have batteries to operate. Refer to the instruction manual for each device to determine the type of battery required.

1.The Assign Wireless Devices screen will appear after setting the master code. To add sensors and Key Chain Remotes, select OK.

2.The device number of the next available device will be displayed. Add the Key Chain Remote included with the Base Unit as the first device. Select OK. The device will not register until OK is selected and then the device reset button is pressed and released.

NOTE: Each device has a reset button that must be pressed and	RESET
released. To locate the reset button, refer to the instructions for each	BUTTON
particular device.
3. Reset the device.

CAUTION: Do not touch the electronic components inside the devices as they are static sensitive.

TO ACCESS THE RESET BUTTON ON THE KEY CHAIN REMOTE

a. Using a flat screwdriver, open the housing. Insert the screwdriver about .25" (6mm) at the tab on the top of the unit. Pry downward on the handle of the screwdriver until the latch holding the cover to the housing base releases.

RESET

BUTTON

b. Install the battery using the polarity (+ and -) markings on the battery and equipment. Do not use excessive force. If the battery does not fit, check to make sure that it matches the polarity markings.

c. When prompted by the Base Unit to RESET DEVICE, press the reset button located inside the Key Chain Remote to register the device. After registering the Key Chain Remote, replace the cover.

4.Only 48 sensors and 6 Key Chain Remotes can be assigned, if there are no slots avail- able, the screen will display ALL DEVICES IN USE. When the device has been regis- tered, the screen will indicate which type of device has been registered. This descrip- tion is the default description set at the factory. To provide further detail, such as the location of the device, the description can be changed by selecting EDIT. To keep the default description, select OK and move to step 7.

NOTE: If the device does not register when you press the reset button, see the Troubleshooting Guide for more detailed information.

List of Devices	Code
Indoor Motion Sensor – PIR	I.MOTION
Door / Window Contact Sensor	DOOR/WIN
Jobsite Security Cable Lock	CABLE
Container Sensor	CONTAIN
Key Chain Remote	KEYCHAIN

5.To edit the device description using the keypad, type a description of up to 8 characters. The character that is being changed will be underlined. To move back a character, use the down arrow. To move forward a character, use the up arrow.

5