Wayne-Dalton 3790-Z Top Bracket, Re-Install If Necessary, 8000/8100/8200 Track

R5	9100 Top Bracket
	Re-Install (If Necessary)
Tools Needed:	If installing an idrive® opener on an installed
Power Drill	9100 door, the top bracket and roller
	location will have to be adjusted for the
7/16" Socket
	opener to work properly.
Driver	Loosen the (2) 1/4”-20 nuts from the top
Step Ladder
	bracket slide.
	Remove the (4) 1/4”-14 x 5/8" self-tapping
	screws from the top bracket.
	Raise the top bracket to align the bottom
	slots with the second set of holes in the
	end cap.
	Re-attach top bracket to the end cap with
	the (4) 1/4”-14 x 5/8" self-tapping screws.
	Re-align the top roller in the horizontal track
	by moving the top bracket slide out to force
	the door section against the weather seal.
	Tighten (2) 1/4”-20 Nuts.
	Repeat for the opposite side.

1/4” - 20	Top
Carriage Bolts	Bracket
and Nuts	Slide
	Horizontal
	Track
1/4”- 14 x 5/8”
Self-Tapping
Screws			-FIT
	Top
			RETRO
	Roller
End Cap	Top
a		b
	Bracket

NOTE: The 9100 doors have a painted steel face, foam insulation and white paper backing. If your door does not match this description you may skip this step.

CAUTION: TO AVOID THE TOP PANEL FROM FALLING, COMPLETE RE- INSTALLATION ON ONE SIDE BEFORE BEGINNING THE OTHER.

R6	8000/8100/8200 Track
	Vertical Track Height Adjustment
	(If Required)
Tools Needed:	NOTE: The door must be in the fully closed
	position.
Power Drill
	If installing an idrive® opener on an
7/16" Socket
	8000/8100/8200 door, the top roller location
Drive	and track height will have to be modified for
Pencil	the opener to work properly. Perform the
Tape Measure	following steps:
Step Ladder	NOTE: The bottom edge of the track needs to
	be spaced 1” above the floor. If the track is
	already spaced off the floor 1”, skip this step.
	Fasten a nail in the door jamb, between the

Flagangle

Remove

Lag Screws

Flange Nut

Nail

Top Bracket Slide

door and the track at the ends of each

section. Bend the nail over each section to

hold them in place.

Remove the lag screws from the flagangle and

each jamb bracket. Using a 7/16" socket

driver, loosen the flange nut on the Top

bracket slide. Place a mark 1" up from one of

the tops of one of the jamb brackets. Raise

the track up and align the jamb bracket with

this line. With the track relocated, re-attach

the flagangle, end bracket, and jamb brackets

to the header and/or door jamb. Make certain

to maintain spacing between edge of door and

vertical track.

NOTE: Pilot drill all lag screw locations.

Track

Nail

Nail

Jamb

Bracket

Nail

Nail Placement

Nail bent over door section

Track

(Door Section)

Please Do Not Return This Product To The Store. Call Us Directly! Our Trained Technicians Will Answer Your Questions and/or Ship Any Parts You May Need. 5 You can reach us Toll Free at 1-888-827-3667 for Consumer Assistance or online at www.wayne-dalton.com