Wayne-Dalton 3790-Z installation instructions Installing Battery

Mounting Wall Station	Lower Screw Installation	Upper Screw Installation
(Continued)

	If mounting to a NEMA electrical device box,
	use machine thread screws provided in
	place of the wood screws. No drilling is
	required. If high voltage wiring is contained
	in the box, a standard NEMA solid faceplate
	must be installed between the box and the
	wall station. If fastening into drywall or
	concrete, use anchors provided. When
	mounting to wood use a 3/32" drill bit and					Phillips
	the drilling template located on page 45.
					Head Screw
	Drill the two 3/32” mounting holes using the
	drill template. Drill 3/16" holes if using
	anchors.
	Install lower screw leaving 7/16" of the
	screw exposed. Slide wall station keyhole
	slot onto the lower phillips head screw. Wall		7/16”
	station should slide onto screw, providing a
	snug fit. If necessary remove wall station
	and loosen or tighten lower phillips head				Keyhole
	screw until a snug fit is achieved.				Slot
	Once wall station is fitted on lower screw,				Phillips
	install upper screw. Do not over-tighten.
					Head Screw
	CAUTION: OVER-TIGHTENING THE UPPER
	SCREW COULD DEFORM PLASTIC CASE.
15	Installing Battery		per
			O	at
			o	e
Tools Needed:	Remove the battery cover (right-hand side		T
		LED		o
				D
	of wall station) by disengaging the battery			o
			Press
None			Here		r
	cover’s lower clip.
	Install two AAA batteries into the wall
	station observing the polarity, (+) and (-),
	of both batteries. After about three seconds,	Wall
	the red LED will begin to blink momentarily
		Station
	every three seconds.						Battery
	Re-install the battery cover by first inserting						Cover
	its top into the wall station then inserting				(2) AAA		Lower
	and securing its bottom.
					Batteries		Clip
	Apply entrapment warning label in a
	convenient location next to the wall station.
	Use mechanical fasteners if adhesive will
	not adhere.		Entrapment
			Label
	NOTE: To slow blink rate or turn off the red				per
	LED, refer to wall station operation page 34
					O	at
					T	D
					o	e
	“Backlit LED Light”.					o
					Press
						o
						Here	r

22Please Do Not Return This Product To The Store. Call Us Directly! Our Trained Technicians Will Answer Your Questions and/or Ship Any Parts You May Need.

You can reach us Toll Free at 1-888-827-3667 for Consumer Assistance or online at www.wayne-dalton.com