Change during operation: N = impossible, Y* = possible (enabled by using
FUNC DATA
), Y= possible (enabled by using 
)
Continued from previous page
7
Link operation selection (LE)
Operation setting can be done by commands from RS485 when the LE terminal is connected to the CM terminal.
A command from RS485 is ignored when the LE terminal is disconnected from the CM terminal.
ON input is assumed when LE is not selected.
LE is valid only when function Note: Set function E 
0 
3 to a value from as a PLC terminal (SW7 is set to PLC).
o 
0 
0 
0
is set to |
|
to | 3 |
1 (option operation).
when using the X3 terminal