GE C11, AF-300 manual Operating Keypad Panel, Is pressed at the same time as

4-2 Operating Keypad Panel

1) Switching monitor

The display can be switched between frequency display and output current display by pressing the DATAFUNC in Operation mode.

FUNC

DATA

6 0. 0

	FUNC
Frequency *1	DATA

1. 2 A

Current *2

*1 Frequency is displayed as a percentage with the least significant digit in PID control operation (function H20 is set to 1 or 2):

1 0. 0. for 10%

1 0 0. for 100%

*2 The reference frequency is displayed when the key is pressed in current indication.

2)Stopping operation

Operation is started when the RUN is pressed, and is stopped when the STOP is

pressed while function F 0 2 is set to 0 , 1 ,or 3 .

The rotation direction is:

Forward rotation with FWD-CM ON, and reverse rotation with REV–CM ON

3)Changing frequency

The frequency increases when the is pressed and decreases when the is

pressed while function F 0 1 is set to	0 .
The change speed is increased when the	FUNC	is pressed at the same time as the
	DATA

or .

Note: Do not turn the power off for five seconds after monitor switching or function setting, to prevent Er1 occurrence.

-31-