GE AF-300, C11 manual Keypad Panel, Names and Functions

		1.	The STOP key is valid only when the function has been set.
			Assign another switch to emergency stops,
			otherwise accidents could occur.
!	WARNING	2.	Operation starts suddenly if alarm reset is done with an running signal
			input. Check that no running signal is input before alarm reset,
			otherwise accidents could occur.
		1.	Do not touch the heat sink,
!	CAUTION		otherwise burns could occur.

4Keypad Panel

4-1 Names and Functions

IDigital display

In program mode: Shows function codes and data codes.

In Operation mode: Shows the output fre- quency and output current,

etc.

In Trip mode: Shows a code indicating the causes of the trip.

IProgram (Reset) key Switches between Opera- tion mode and Program mode.

In Trip mode: Resets the trip status and change to Operation mode.

P R G

RESETRUN

FUNC

STOP

DATA

IRUN key

This key is used to start opera- tion.

The LED is on during operation. This key does not function when the data code from the external signal (digital input) is selected (F02 = 1~4).

ISTOP key

This key is used to stop op- eration.

This key does not function when the data code from the

				I Up/down keys
IFunction/Data key					In Operation mode:
					Used to increase and
	In Operation mode:		Switches
					reduce the frequency
	between	frequency	display and
	output	current display during			(motor speed).In Pro-
	stopped and running. In Program				gram mode: Used to
					change a function code
	mode: Used to read and write				and data value.
	various function codes and func-
	tion data items.

-30-

external signal (digital input) is selected (F02 = 2 or 4).