GE AF-300, C11 manual Control terminal block arrangement

!CAUTION

1.Noise is generated from the drive, motor, and wiring. Take care that this noise does not cause malfunctions in peripheral sensors and equipment, otherwise accidents could occur.

(4)Control terminal arrangement, screw size, and tightening torque Figure 2-3-7 shows the control terminal block arrangement. Screw size: M2.5 Tightening torque: 3.5 lb ·inch ( 0.4 N· m)

30A 30B 30C FM X1 X2 X3 FWD REV CM 11 12 13 C1

Figure 2-3-7 Control terminal block arrangement

(5)Remove the plate at the bottom of the surface cover before performing drive control wiring and rein- stall it after the wiring as shown in Figure 2-3-8.

Plate Control wiring

Figure 2-3-8 How to pull out the control wiring

-20-