Change during operation: N = impossible, Y* = possible (enabled by using | FUNC |
| DATA |
C01 | C02 | C03 Jump frequency 1, 2, 3 |
), Y= possible (enabled by using | ) | ||
|
|
|
|
|
| Factory | Change during |
|
| setting | operation |
| C01 | 0.0Hz | Y |
| C02 | 0.0Hz | Y |
| C03 | 0.0Hz | Y |
These functions jump frequencies to prevent overlap be- tween the load mechanical resonance point and drive output frequency.
Up to three jump points can be set.
These function do not operate when 0Hz is set.
No frequency is jumped during acceleration and decel- eration.
If three continuous frequencies are set, the total of the three jump widths is set as the jump width.
Output Frequency |
| |
Jump |
| |
frequency | Jump width | |
Jump | ||
| ||
frequency | Jump width | |
| ||
Jump |
| |
frequency | Jump width | |
| Frequency setting |
C04 Jump frequency (Hysteresis)
Factory | Change during |
setting | operation |
3Hz | Y |
This function sets a jump width in a range from 0 to 30Hz in 1Hz step.
C05 Multistep frequency setting 1
C06 Multistep frequency setting 2
| Factory | Change during |
| setting | operation |
|
| |
C05 | 0.0Hz | Y |
C06 | 0.0Hz | Y |
C07 | 0.0Hz | Y |
C07 Multistep frequency setting 3
These functions set a multistep frequency setting from 0 to 120Hz in 0.1Hz step (for 99.9 Hz or less) or 1Hz step (for 100Hz or more) by switching the external contact signal.
The ON and OFF of terminal function SS1/SS2 (see explanation of E01, E02, and E03) switches between the frequencies set by these functions C05, C06, and C07.
P00 Motor characteristics
Factory | Change during |
setting | operation |
| |
2 | Y |
This function removes abnormalities in the output current such as current vibration. 0 Current vibration is not suppressed.
to
1 0 Current vibration is minimized.