Jenn-Air 8113P759-60 Number in the display, Is obtained, Authorized servicer, Noises may be heard

Page 12

PROBLEM

SOLUTION

Oven will not self-clean.

• Check to make sure the cycle is not set for a delayed start. See pg. 5.

 

• Check if door is closed.

 

• Check if control is in Sabbath Mode. See pg. 27.

 

• Oven may be over 400° F. Oven temperature must be below 400° F to program a

 

clean cycle.

 

 

Oven did not clean properly.

• Longer cleaning time may be needed.

 

• Excessive spillovers, especially sugary and/or acidic foods, were not removed prior

 

to the self-clean cycle.

 

 

Oven door will not unlock after

• Oven interior is still hot. Allow about one hour for the oven to cool after the

self-clean cycle.

completion of a self-clean cycle. The door can be opened when the LOCKED

 

indicator word is not displayed.

 

• The control and door may be locked. See pg. 15.

 

 

There are no beeps and

• Oven may be in Sabbath Mode. See page 27.

no display.

 

 

 

Moisture collects on oven

• This is normal when cooking foods high in moisture.

window or steam comes from

• Excessive moisture was used when cleaning the window.

oven vent.

 

 

 

There is a strong odor or light

• This is normal for a new range and will disappear after a few uses. Initiating a clean

smoke when oven is turned on.

cycle will “burn off” the odors more quickly.

 

• Turning on a ventilation fan will help remove the smoke and/or odor.

 

• Excessive food soils on the oven bottom. Use a self-clean cycle.

 

 

Fault Codes

• The oven may detect a fault during programming or during operation. If a fault is

 

detected, the message FAULT DETECTED - PRESS POWER TO CLEAR or FAULT

 

DETECTED - PRESS ENTER TO TRY AGAIN may appear. Follow directions in the display.

 

If the fault reappears or does not clear, call an authorized servicer or the toll-free

 

number in the display.

 

• If the same operation is attempted before having the oven repaired, the message

 

FEATURE NOT AVAILABLE will appear. The feature will remain inoperable until service

 

is obtained.

 

• If the oven is heavily soiled, excessive flareups may result in a fault code during

 

cleaning. Press the CANCEL pad and allow the oven to cool completely, wipe out

 

excess soil, then reset the clean cycle. If the fault code reappears, contact an

 

authorized servicer.

 

 

Noises may be heard.

• The oven makes several low-level noises. You may hear the oven relays as they go on

 

and off. This is normal.

 

• As the oven heats and cools, you may hear sounds of metal parts expanding and

 

contracting. This is normal and will not damage your appliance.

 

 

SAb flashing and then

• Oven is in Sabbath Mode. To cancel, press and hold the Setup pad for five

displayed continuously.

seconds.

 

 

Cannot add another Favorite.

• Favorites is full. To delete a favorite and add another, see page 25.

 

 

11

Page 11 Page 13
Image 12
Page 11 Page 13
Contents USE & Care Guide Recognize Safety Symbols, Words, Labels General InstructionsChild Safety To Prevent Fire or Smoke DamageCase of Fire About Your ApplianceCooking Safety Utensil SafetyCleaning Safety Self-Clean OvenImportant Safety Notice and Warning Deep Fat FryersCare & Cleaning Before Self-CleaningTo set Self-Clean To Delay a Self-Clean CycleCleaning Procedures After Self-CleaningPart Procedure Broiler PanTo restore ease of movement, then wipe off excess oil Select modelsStorage Drawer Damage the surface Select models DoorMaintenance Oven DoorLeveling Legs Oven LightElectrical Connection Storage Drawer select modelsRemoval of Gas Appliance Troubleshooting Problem SolutionAuthorized servicer Number in the displayIs obtained Noises may be heardOperating During a Power Failure Surface CookingSurface Controls Pilotless IgnitionCooktop Sealed BurnersHigh Performance Burner Low Turn Down BurnerOven Cooking Control PanelClock Quickset PadsTimers Locking the Control and Oven DoorTo set a Delay BakingBake Options To set BakeConvect select models Convect OptionsConvect Bake select models Rapid Preheat select modelsWarming Chart Suggested SettingsWarming Drawer select models Convect Roast select modelsBroiling Chart BroilTo set Broil Suggested Rack Foods Broil Time PositionOven Fan Oven VentOven Bottom Oven RacksDelay OptionsMore Options Keep Warm Suggested Internal Food Temperatures Drying select modelsTo set Drying Drying Guide select models AT MIN. DRY TimeVegetables HerbsFavorites FavoritesSetup SetupLanguage Auto Convect Conversion Select modelsSabbath Mode Temp AdjustTones beeps Accessories ServiceHR Shutoff Energy SaverJENN-AIRCOOKING Appliance Warranty 31-34 35-3738-39 40-41Respectez Toutes LES Instructions D’INSTALLATION Instructions DE Sécurité ImportantesInstructions générales Toute Cuisinière Peut Basculer ET Provoquer DES BlessuresPour éviter un incendie ou des dommages causés par la fumée En cas d’incendieSécurité des enfants Familiarisation avec l’appareilCuisson et sécurité Ustensiles et sécuritéFriteuses Hottes d’extractionNettoyage et sécurité Four autonettoyantEntretien ET Nettoyage Avant l’autonettoyageProgrammation de l’autonettoyage Pour différer l’autonettoyageTechniques de nettoyage Après l’autonettoyageRemarques Pièce NettoyageTableau de De cuissonPanneaux Rangement Produits rayeraient ou endommageraient la surfaceEntretien Porte du fourHublot du four Pieds de mise à niveauDéplacement d’un appareil à gaz Tiroir de rangementRaccordement électrique Certains modèlesProblème Solution Dépannage’autonettoyage ne se fait pas Vérifiez que la porte est ferméeLa porte du four ne Fonctionner tant que la réparation n’aura pas été effectuéeCommandes de la surface de cuisson Boutons de commande de la surface de cuissonCuisson SUR LA Surface Allumage sans flammeSurface de cuisson Brûleurs scellésBrûleurs de haute performance Brûleur de faible puissanceTableau de commande Cuisson AU FourTouches rapides HorlogeVerrouillage des commandes et de la porte du four MinuteriesCuisson au four Options de cuisson au fourProgrammation de la cuisson au four Pour programmer la cuisson et maintienCuisson à convection Convection certains modèlesOptions de convection certains modèles Rapid Preheat Préchauffage rapide certains modèlesConvect Roast Rôtissage à Tiroir de réchauffageTableau de réchauffage Remarques sur le tiroir de réchauffageCuisson au gril Tableau de cuisson au grilProgrammation de la cuisson au gril AlimentsVentilateur du four Évent du fourLampe du four Sole du fourAutres options Cuisson et maintien certains modèlesDémarrage différé Maintien au chaud Pour réchauffer des petits painsSonde thermique certains modèles Pour réchauffer des assiettes Si vous choisissez BakeTempératures internes suggérées Deshydration certains modèlesProgrammation de la dessiccation Guide de deshydration certains modèles Réglage Favori Réglage favoriRéglage RéglageLangue Mode sabbat Ajustement de la températureSignaux sonores bips Accessoires Service à la clientèleArrêt automatique 12 heures Économie d’énergieGarantie DES Appareils DE Cuisson JENN-AIR Guía DE USO Y Cuidado Última páginaInstrucciones Importantes Sobre Seguridad Instrucciones generalesJennair Instrucciones general Para evitar daños a causa de un incendio o humoEn caso de incendio Seguridad para los niñosInformación sobre su electrodoméstico Información de seguridad sobre la cocciónInformación de seguridad sobre los utensilios Ollas freidorasCampanas de ventilación Información de seguridad sobre la limpiezaAviso y adverntencia importantes de seguridad Conserve estas instrucciones para referencia futuraCuidado Y Limpieza Antes de la autolimpiezaPara programar la autolimpieza Para diferir un ciclo de autolimpiezaProcedimientos de limpieza Después de la autolimpiezaNotas Pieza ProcedimientoCubierta PanelesManijas de la Pintado Ventanilla yMantenimiento Puerta del hornoVentanilla del horno Tornillos niveladoresConexión eléctrica Desinstalación de un electrodoméstico a gasCajón de almacenamiento Modelos selectosProblema Solución Localización Y Solución DE AveríasEl horno no se autolimpia Verifique que la puerta esté cerradaPara poder programar un ciclo de autolimpieza Del ciclo de autolimpiezaCocción EN LA Cubierta Controles superioresEncendido sin piloto Funcionamiento durante una falla eléctricaCubierta Quemadores selladosQuemador de alto rendimiento Quemador de nivel bajoCocción EN EL Horno Panel de ControlTeclas rápidas RelojProgramación de los temporizadores Timer 1 o Timer Programación del día de la semanaPara programar el reloj en formato de 12 o 24 horas Anulación del temporizadorPara programar la función Delay Diferido HorneadoOpciones de horneado Para hornearConvect Bake Horneado por Rapid PreheatConvect Roast Asado por Warm DrawerGaveta calentadora modelos selectos Tabla de calentamientoBroil Asar Tabla de asarPara asar a la parrilla ParrillaVentilador del horno Respiradero del hornoParte inferior del horno Parrillas del hornoDelay Diferir OpcionesMás opciones Keep Warm Mantener caliente Para calentar panecillosPara calentar platos Meat Probe Sonda para carne modelos selectosTemperaturas internas para los alimentos Drying Secado modelos selectosPara programar el secado TemperaturaGuía de secado modelos selectos Favoritos Favorites FavoritosPara guardar la última receta terminada Para crear una nueva receta favoritaSetup Ajuste AjusteClock Reloj IdiomaModo sabático Service Servicio Tonos BipsAccesorios Garantía DE LOS Aparatos DE Cocción DE JENN-AIR
Top Page Image Contents