DCS 36/48BGB manual Side Burners BGB48 BQR Model, Smoker Burner

Page 32

CARE AND MAINTENANCE

Fig. 48

Note:

When replacing grill and/or smoker burners, or orifices following cleaning, confirm orifice penetration into burner as shown in Fig. 48

Be careful not to upset the air shutters’ original posi- tion (unless readjusting). Lower the rear of the burner into the cutouts on the support channel at the rear of the burner box. Make sure it is level and does not rock. Light all of the burners and check for proper flame characteristics. If adjustments are necessary, refer to page 17. Do this prior to cooking on the grill.

SIDE BURNERS (BGB48 BQR MODEL):

For proper lighting and performance keep the burn- ers clean. It is necessary to clean the burners if they do not light even though the electrode clicks, if there has been a severe boil over, or when the flame does not burn blue. Be certain all burner knobs are in the off position before attempting to clean the burners. The burners have been designed for ease in clean- ing. When the grates and burners are cool, remove the grate. The burner cap and the brass port ring can easily be lifted off. Wash these parts in hot soapy water, rinse and dry thoroughly. The burner caps are porcelain enamel. Follow the directions on the previ- ous page for cleaning that were given for the burner grates. A bristle brush can be used to clean out the toothed burner ports, if necessary. After cleaning, it is important to make sure the location pins on the bot- tom side of the port ring are properly aligned with the corresponding holes in the base. Incorrect alignment will produce a potentially dangerous flame and poor burner performance (see Fig. 49).

		Cap
	Brass Ring	Main
	Locating Pins	Main
	Locating Pins	Burner
		Burner
		Port Ring
		Locating Notch
	Electrode
		Burner
		Base
		Venturi
		Locating Holes

FIG. 49

SMOKER BURNER:

The smoker burner can be removed and cleaned by unplugging the electrode wire and lifting out the burner. Cleaning is similar to the grill burner. Replace the burner by sliding the air shutter over the brass orifice, center- ing it in the hole.

30

Image 32

Contents User guide Page Message to OUR Customers Please Retain this Manual for Future ReferenceTable of Contents Safety Practices & Precautions Important Safety NoticeGrill Placement AIR FlowSafety Practices & Precautions Grill Models Location InstallationLocating GRILL/BUILT-IN Clearances Clearances to Non-Combustible Construction Clearances to Non-Combustible ConstructionInsulated Jacket Clearances to Combustible ConstructionGeneral BUILT-IN Construction Details Access Drawers Cutout dimensions GAS HOOK-UP LP Tank Requirements LP GasLP Tank Restraint for BUILT-IN Installation Center of manifold cut out projected to floor of the islandStep To Test Leak TestingBefore Testing Burner Adjustment Grill Burner AIR AdjustmentLOW Flame Setting Adjustment Grill Burner Flame HeightRadiant Assembly Radiant Asssembly InstallationInstaller Checklist Using the Grill Lighting InstructionsTo Light the Grill Burner To Light Dual Side Burners 48BQR Models onlyGrilling GrillDIRECT/INDIRECT Cooking Notes Burner OffShaped Grate Radius Grate Grilling HintsDUAL-SIDED Grates Wood Chips Using the Smoker SystemTo Light the Smoker Burner Using the Rotisserie Preparation RecommendedWorking Area Meat PreparationTo Light the Rotisserie Burner Before Cooking Manual LightingCooking on Rotisserie Care and Maintenance To Remove the U-BURNERS for Cleaning Grill Burner CleaningOrifice Cleaning Stainless SteelSide Burners BGB48 BQR Model Smoker BurnerTroubleshooting Before Calling for ServiceGrill WON’T Light When the Ignition Button is Pushed LOW Heat with Knob in HI/SEAR PositionService HOW to Obtain ServiceWarranty Limited WarrantyHOW Long does the Limited Warranty LAST? This Warranty does not CoverNo Other Warranties HOW to GET ServiceCommercial USE Page Page ’INTENTION DE NOS Clients Veuillez Conserver CE Manuel À Titre DE RéférenceTable DES Matières Mesures DE Sécurité ET DE Précaution AutocollantDe ventilation Emplacement DU Gril Flux Dair PréféréRemarque Modèles DE Gril Emplacement DU Gril ET DES Dégagements EmplacementEspaces de dégagement pour une construction non combustible Généralités Enveloppe IsoléeDétails D’UNE Construction Intégrée Disposition standard pour une enceinte non combustibleModèle Branchement DU GAZ Exigences Concernant LE GAZBranchement DU GAZ Naturel Pour Connecter LES Raccords Fournis Avec LE GrilMise EN Garde Exigences Concernant LA Bouteille DE PropaneRemarque Placez le dispositif de retenue de bouteille dans l’îlot Fig Pour tester Test DE Détection DES FuitesAvant la vérification Réglages DES Brûleurs Réglage D’AIR DU Brûleur DU GrilHauteur DES Flammes DU Brûleur DU Gril Réglages Pour Niveau BASInstallation DE L’ENSEMBLE DU Radiant Installation DE L’ENSEMBLE DU RadiantListe DE Contrôle DE L’INSTALLATEUR Utilisation DU Gril Instructions D’ALLUMAGEPour Allumer LE Brûleur DU Gril Allumage du gril à l’allumetteInstructions D’ALLUMAGE/CUISSON SUR Gril Allumage des brûleurs latéraux avec une allumetteBrûleurs latéraux GrilCuisson SUR Gril Conseils AU Sujet DU GrilGrilles Double Face Grille EN Forme DE « W » Grille ArondieCopeaux DE Bois Utilisation DU Système À FumoirPour Allumer LE Brûleur À Fumoir Utilisation DE LA Rôtissoire Recommandé PréparationPour Allumer LE Brûleur DE Rôtisserie Avant DE Faire Cuire Allumage ManuelCuisson SUR LA Rôtissoire Entretien ET Nettoyage Acier Inoxydable ÉlectrodesBrûleur DU Gril Déposer DES Brûleurs EN U Pour LE NettoyageBrûleur À Fumoir Brûleurs LatérauxBGB48 BQR Modele Avant D’APPELER LE Service Technique DépannageChaleur Faible Avec LE Bouton EN Position « SEAR/HI » LA Rôtissoire NE S’ALLUME PASPour L’OBTENTION DU Service DE Garantie Garantie Garantie LimitéeFisher & Paykel S’ENGAGE À Quelle EST LA Durée DE LA Garantie LIMITÉE?Aucune Autre Garantie Pour Obtenir DES RéparationsUtilisation Commerciale Remarque US CA