TROUBLESHOOTING:
FRYING SYSTEM:
Should there be a problem with your machine, the following checks should be done prior to calling an Authorized Service Company. Make sure the machine is operated correctly and that the Computer or Digital Display (when installed) is programmed accordingly.
Check these items before calling your Authorized Service Company
ITEM TO CHECK | HOW TO CHECK |
Power to machine | Check main power to machine (When applicable.) |
|
|
Press | |
| pivot assembly |
|
|
Power switch on | Power switch should be in the ON position. |
|
|
|
|
Locate the problem in the chart below then follow the instructions in the above chart. | |
|
|
PROBLEM | ITEM TO CHECK |
Machine will not run: | Power to machine (Where applicable.) |
No lights on the front panel | Bad Transformer |
|
|
Machine will not run: | |
Front panel lights are ON. | Bad probe, Temperature control |
|
|
Machine will not maintain temp: |
|
Is machine still running? YES | Bad probe |
NO | Bad Hi Limit |
|
|
Oil temp too hot or Machine runs constantly | Check Thermostat calibration (Where applicable.) |
| Call Authorized Service Company |
|
|
FILTERING SYSTEM:
Check these items before calling your Authorized Service Company
PROBLEM | CHECK |
Power to machine | Check main power to the machine |
|
|
Circuit breaker | Check filter circuit breaker on side of filter handle |
|
|
Motor overheat trip | Remove cap on the left side at the rear of filter and push red |
| button |
|
|
Shortening return quick disconnect | Fitting should be tight and clean |
|
|
Pick up tube | Steel nut should be tight on the filter Pick up screen |
| inside tube should be clear |
| Fitting at top of tube should be tight |
|
|
Paper installation | Paper should be installed per directions in the manual |
|
|
Pick up screen | Check the small screen in the end of the pick up tube (Inside |
| the large steel nut.) to make sure it is clear |
|
|
Filter pump NOT running | Check power to machine |
| Check circuit breaker |
| Check motor overheat trip |
|
|
Filter pump running | Check quick disconnect |
| Check pick up tube is attached correctly |
| Check paper installation |
| Check pick up screen installation |
|
|
ENGLISH
6