Luxury Whirlpool Bath
Framing
A technical specifications manual has been included with your bathtub. The Technical Specifications Manual will contain pertinent information regarding your Jacuzzi Luxury Bath product. Locate the Technical Specifications Manual at this time.
English
Frame out the space where the bathtub is to be located. The following should be taken into consideration when preparing the area:
•Dimensions provided on
•The floor structure beneath the bathtub must be able to support the total weight of the bathtub, water and bather.
•The unit must be supported from the bottom of the bathtub and not from the bathtub rim. For
•Ensure the rim will rest on a level surface.
•Per code, access must be provided to the motor/pump for your specific model. Primary and secondary service access locations are shown in the
Figure 1 shows common access locations.
It is the responsibility of the installer, building contractor, or owner to provide access for service. Jacuzzi is not responsible for any costs relating to obtaining access for repair. The owner shall bear such costs and, if appropriate, must seek recovery from the installer.
• | Provide adequate ventilation for cooling and supply |
sufficient air for the motor/pump. Do not insulate | |
| around the equipment. |
Common Access Locations
|
|
| 12˝ |
|
|
| (304mm) |
|
| Primary |
|
12˝ |
| Access | 18˝ |
Secondary |
| (457mm) | |
(304mm) |
|
| |
| Access |
|
|
| 18˝ | Blower |
|
(457mm) |
| ||
Figure 1
18˝
(457mm)20˝ (508mm)
C
B | Blower |
|
• Your bathtub may have motor/pump parts that extend |
36˝
A
beyond the rim of the bathtub. Refer to the |
diagrams included in the warranty pack and |
construction framing to correctly accommodate. |
(914mm)
24˝
(609mm)
A= Primary access
B= Acceptable alternative if access A is not possible
C= Secondary access for equipment (optional)
Left hand unit access is on the opposite side (mirror).
Figure 2
Installation and Operation | www.jacuzzi.com | Page 7 |