Luxury Whirlpool Bath
Fuzion™ Specific Material
The additional design features of the Fuzion™ require that the following steps be completed prior to installing the bathtub in the constructed surround. The following steps must also be completed in the order specified:
•Fuzion™ Overflow/Drain Installation
•Fuzion™ Wood Frame Installation
•Fuzion™ Control Panel Installation
Fuzion™ Faucet Installation
Selecting a faucet for rim mounting: The combined thickness at the rim of the bathtub shell and optional wood deck is 2˝ (50mm) nominal. The length of the faucet tailpiece(s) must be long enough to extend past this dimension and have ample clearance to assemble any hardware (i.e. locknut, water supply fittings, etc.) necessary for installation. For undermount units, the combined thickness of the bathtub shell is ½˝ (12mm) nominal and the undermount deck should not exceed the length of the faucet tailpiece(s), including any assembly hardware.
English
Fuzion™ Overflow Drain Installation
Assemble in accordance with the local plumbing or building codes.
1Identify drain overflow kit provided with your bathtub. Remove and open the overflow package and confirm that all parts are present.
2Remove washers and nuts from the overflow fitting.
3Place a small bead of plumbers putty, silicone, or similar approved sealant around the underside of the top flange of the overflow fitting.
4Place the overflow fitting into the overflow hole of the bathtub (Figure 3).
5From the underside of the unit, place the rubber washer then locknut on the overflow fitting and tighten securely. Be careful not to overtighten.
6Assemble the remaining drain pieces as shown in the illustration.
7After the drain is fully installed, test for proper drainage. If the unit does not drain properly, rectify this condition before proceeding with further bathtub installation.
Watertight installation of the drain and overflow is the installer’s responsibility. Drain leakage is excluded from the Jacuzzi Luxury Bath warranty of this product
Overflow Fitting
Apply sealant/caulking (commercially available)
Flat Rubber
Washer
Lock Nut
Direct Waste Overflow Drain
Figure 3 - Overflow Installation
Overflow Drain
Assembly
Direct Waste
Overflow Drain
PVC 45
Elbow Street
PVC Flex Pipe 
PVC 45 Elbow
PVC Flex Pipe
PVC 45 Elbow
PVC Flex Pipe
PVC 45 Elbow Street
Twist and Turn
Drain Assembly
PVC Pipe |
|
PVC Pipe | Waste Elbow |
|
OPTIONAL - If the Fuzion™ Wood Frame is not being used, please proceed to Step 2 in the Undermount Installation section.
Installation and Operation | www.jacuzzi.com | Page 9 |