3D Innovations NC60 manual Cleaning the Printer, Cleaning the Print Drum Charger

Models: NC60

1 186
Download 186 pages 19.83 Kb
Page 138
Image 138
Cleaning the Printer

Cleaning the Printer

Cleaning the Printer

Cleaning the Print Drum Charger

The cleaning procedures described in this section will help you maintain the optimum print quality and minimize downtime of your DocuPrint NC60. Before you begin, be sure that you have a basic understanding of the parts of your printer. Also, pay strict attention to the cautions given in each process.

The Print Drum Charger is a thin wire mesh used to place a charge on the Print Drum. If this mesh becomes dirty the Print Drum will not obtain a proper charge resulting in image quality defects. To clean the Print Drum Charger, follow these steps.

1

Open the front and top covers of the printer and locate

 

the Print Drum.

2

On the top left side of the Print Drum you will see a green

 

thumb tab. This is the Print Drum Charger cleaner slide.

3

Simply slide this Print Drum Charger cleaner slide back

 

and forth several times and return it to its original

location.

4-4 DocuPrint NC60 System Administrator Guide

Page 138
Image 138
3D Innovations NC60 manual Cleaning the Printer, Cleaning the Print Drum Charger