3D Innovations NC60 manual

Models: NC60

1 186
Download 186 pages 19.83 Kb
Page 145
Image 145

Adjusting Density and Color Balance

What To Look For There are basically three things to look for in examining the test print.

1.The Color Density and the Black Density are a matter of taste. The 30% halftones can be used to judge the current level and decide on a preference.

2.The Color Density and Black Density should be at approximately the same level. This is important in order to make the Color Balance adjustment.

3.The correct Color Balance is determined by comparing the circle in the center of the Color Balance object marked “CURRENT” with the gray background. The background is produced using black only and the circles are produced using a combination of cyan, magenta, and yellow. The adjustment objective is for the “CURRENT” circle to be the closest gray of any of the circles when compared to the background.

Chapter 4: Maintaining the Printer 4-11

Page 145
Image 145
3D Innovations NC60 manual What To Look For There are basically three things to look for in examining the test print