3D Innovations NC60 15 Ethernet Menu functions continued, Menu Item and Function, Keystrokes

Ethernet Menu

Table 1.15 Ethernet Menu functions (continued)

Menu Item and Function	Keystrokes	Display
Default Gateway	1. Press Menu Up or Menu	Menus
Set the four byte Default Gateway	Down until you see:	Ethernet Menu
address.	2. Press Item Up or Item Down	Ethernet Menu
The available values are:	until you see:	Default	Gateway
xxx.xxx.xxx.xxx
	3. Press Value Up or Value Down.	Default	Gateway=
(where xxx = 000 to 255)
	You will see:	xxx.xxx.xxx.xxx
For this item (after Step 3), Item Up
moves the cursor to the right through	4. Press Value Up or Value Down	Default	Gateway=
the displayed Default Gateway
	to change the value of the	xxx.xxx.xxx.xxx
address and Item Down moves the
	character above the cursor. The
cursor to the left. This allows you to
	value is incremented or
change characters within the string
	decremented by 1 each time
rather than having to reenter the
	the key is pressed. Holding
entire string.
	down Value Up or Value
With the cursor displayed under a	Down causes continuous
character, Value Up increments the	scrolling through the values.
value of that character and Value
	5. To change other characters in	Default	Gateway=
Down decrements the value.
	the Default Gateway address,	xxx.xxx.xxx.xxx
This item appears only if	press Item Up or Item Down
IP Address Res is set to Static.	to scroll right or left
	respectively through the
	character string, then press
	Value Up or Value Down to
	change the value of the
	character above the cursor (as
	in Step 4).
	6. When you have completed	Ethernet Menu
	setting the Default Gateway	Default	Gateway
	address, press Enter. You will
	see:
	7. Press Online. You will see:	Ready

8.Restart printer or power off/on. Table 1.15 Page 9 of 10

Chapter 1: Configuring the Printer ❖ 1-67