3D Innovations NC60 Procedure D, Insert into Novell Queue, Upgrading the Printer Software, Return

Upgrading the Printer Software

Procedure D	Insert into Novell Queue
		Once the upgrade process has begun do not power
		off your printer!
	1	Print a Configuration Sheet and a Diagnostics Page.
		Keep these pages for future reference. For directions on
		doing this, refer to Table 1.20 on page 1-101.
	2	Start PCONSOLE.
	3	Select Print Queue Information then press [RETURN].
	4	Select the print queue to send the job to, then press
		[RETURN].

5	Select Current Print Job Entries then press [RETURN].
6	Press the [INSERT] key. Type in the path/filename and
	press [RETURN].
7	Choose configuration and then press [RETURN].
8	Press the [ESC] key. Select Yes then press [RETURN].
9	The upgrade file will be sent to the printer. The upgrade
	should take less than 10 minutes to perform.
10	To see if your upgrade was successful, see the section

“Determining a Successful Upgrade” (page 4-20). If successful, follow the instructions in the section “After the Upgrade” (page 4-20).

4-26 ❖ DocuPrint NC60 System Administrator Guide