Input Type (Thermocouple)
ENTER INPUT TYPE MENU:
Press a 1) Press a, if necessary, until CNFG prompt appears. Press d 2) Display advance to INPT Input Menu.
Press d 3) Display flashes T.ç, RTD or PROC (Thermocouple, RTD or Process). If the displayed input type is T.ç, press a to skip to step 6 (T.ç stops flashing).
THERMOCOUPLE SUBMENU:
Press b 4) Scroll through the available selection to T.ç (flashing). Press d 5) Display shows STRD stored message momentarily and then
T.ç (not flashing).
Press d 6) Display flashes previous thermocouple type selection. i.e. J (see below for types).
Press b 7) Scroll through the available thermocouple types to the selection of your choice.
Press d 8) Display shows STRD stored message momentarily and then advances to the RDG Reading Configuration Menu.
Use the Input Type (Thermocouple) (RTD) or (Process) and verify your Electrical Installation (see Section 2.3). See the following pages for (TC), (RTD), (Process) menus.
Thermocouple Types: | J, | K, | T, | E, | N, | DIN J, | R, | S, | B, | C |
Display: | J | K | T | E | N | DNJ | R | S | B | C |
19
