Accton Technology 1500 manual Preparing for System Configuration

EtherHub 1500 System User’s Guide

The unit will automatically select the setting that matches the input voltage connected. Therefore, no additional adjustments are necessary when connecting it to any input voltage within the range marked on the rear panel.

ΦThe unit supports a "hot remove" feature which permits you to connect/disconnect cables without powering off the hub and without disrupting the operation of the hubs in stack.

Preparing for System Configuration

If you are installing the EtherHub-16mi+, prepare it for out-of- band management, if necessary.

Local Out-of-Band Configuration

If you use a local PC to configure the EtherHub 1500, connect the converter for the PC’s COM port (COM1, COM2, COM3 or COM4) to the converter for the EtherHub-16mi’s serial port (RS232) using the UTP cable with DB9 connectors at both ends - provided as part of the Product Package.

ALT PORT

FlexBus 1500	SERIAL PORT
	This device complies with Part 15 of the FCC
	Operation is subject to the following two
	(1) This device may not cause harmful
	(2) This device must accept any interference
	including interference that may cause

IN OUT

90-260 VAC

47 -63Hz 1A

ON

OFF

DB9 to RJ-45 Connector

to Hub

PC

to PC

DB9 to RJ-45

Connector

Figure 3.3 Connecting the Hub’s RS232 Serial Port to a PC COM Port

Hardware Installation 3-7