EtherHub 1500 System User’s Guide
∙A "short press" is used to switch between the selections available within each function. For example, in Segment Setting, there are 4 selections available. By using a "short press" on the Configure button, you can move from one selection (e.g., Attach hub to Segment 1) to the next (e.g., Attach hub to Segment 2). Note, however, that a selection will only take effect after a "long press" on the Configure button.
∙If the button is not pressed within 10 seconds, the system returns to normal operation effecting all changes made prior to selecting the current function.
To summarize,
1.Access configuration functions by using a "long press". LEDs light up to indicate the current configuration function. (Example: Hub ID LEDs will display a combination of BLINKING/OFF lights to indicate that the system is in Hub ID Setting mode.)
2.Compare the LED display you see on the hub’s front panel with the appropriate LED display in the succeeding pages. Each LED display corresponds to a selection within a function. (Example: If the system is in Segment Setting function, see the LED display table under Segment Setting Function in this chapter).
3.If you want to implement the selection displayed for your hub, proceed to step 4. Otherwise, move to the next selection using a "short press". Repeat a "short press" until you find the selection you want.
4.To implement your selection and continue on to the next function, use a "long press".
Setup and Configuration |
