Accton Technology 1500 manual From a local console

EtherHub 1500 System User’s Guide

To activate a selection press the keyboard character corresponding to the highlighted character on screen. Or, use the arrow keys to move to the selection and press [Enter].

Activate the EtherHub 1500 System Configuration Program from a local console or via modem connection as described below. This will open the communication dialog box shown in Figure 4.1.

From a local console -

Type “ EH15SCP” at the DOS prompt C:\>EH15SCP

From a remote modem connection -

∙When using a PCMCIA FAX/Modem, first add the following entry to your config.sys file: device=cardtalk.sys /A /Com3IRQ=4

∙If your PC has a PCMCIA Fax/Modem or multi-I/O card, set the proper IRQ by typing “ EH15SCP/i [irq #]”. Help is available by entering “ EH15SCP/?” .

Figure 4.1 Communication Port Dialog Box

3.Using arrow keys, select the workstation’s communication port connected to the EtherHub-16mi+. The DCE/DTE dialog box will appear as shown in Figure 4.2.

4-6 Setup and Configuration