ADC AD-540, WDA-540, AD-295 Coin Mode Coin, Flash Display Status FLS, BAD Coin Lockout Status bCLO

COIN MODE (COIN)

In this program mode (“Coin”), coins are required to start the dryer, even if the Phase 5 coin microprocessor controller (computer) is set in the Automatic Mode (Patent No. 4,827,627).

NOTE: When programming the use of the Coin Mode, (“Coin”), the following parameter/programs need to be checked and/or changed accordingly:

PL01	“AUtO” (automatic drying cycle) or
PL02*	“tInE” (timed drying cycle) “FrEE”
	“PdrY” (percent dry)
PL11	“tFAS” (time for amount to start)
PL12	“AtSt” (amount to start)
PL14*	“Adrt” (maximum auto dry time)
PL17*	“A” and “b” Factors

*Needs to be programmed only if PL01 “AUtO” Cycle is chosen.

FLASH DISPLAY STATUS (FLS)

When the Phase 5 coin microprocessor controller (computer) is set in this program status (“FLS”) it allows the light emitting diode (L.E.D.) readout to display “FILL” and/or “FrEE” (no cycle in progress), and/or “Amount To Start” (PL12) or, in the case of free dry, “FrEE.” The programming allows the L.E.D. readout to flip-flop back and forth every 2-seconds from “FILL” to “Amount To Start,” or in the case of free dry, from “FILL” to “FrEE.” If the L.E.D. display is programmed for “No Flash” (“nFLS”), the microprocessor controller (computer) will then prompt you on whether you would like “FILL” displayed or the “Amount To Start” (“AtSt”).

BAD COIN LOCKOUT STATUS (bCLO)

In this program status (“bCLO”), each coin entry is monitored. Should someone tamper with the coin acceptor or attempt to insert a foreign object, the Phase 5 coin microprocessor controller (computer) will “LOCKOUT” and not accept any entries until the reset time has elapsed (approximately 15-seconds). Once the reset time has expired, the Phase 5 coin microprocessor controller (computer) will automatically reset itself immediately for the next entry.

BAD COIN RESET (bCrS)

When set in this program (“bCrS”), the Phase 5 coin microprocessor controller (computer) counts in milliseconds the amount of time required for a coin entry signal. If someone should tamper with the coin acceptor or attempt to insert a foreign object, the Phase 5 coin microprocessor controller (computer) will not accept the entry and will automatically reset itself immediately for the next entry.

17