ADC AD-295, WDA-540, AD-26, AD-540 user manual Program Location 09 PL09, PL09 Perm Press LCdE

L. PROGRAM LOCATION 09 (PL09)

Left Coin Denomination

Refer to Section V for instructions on entering program locations.

Amount Decrease

LO Temp

("Hold In" to Accelerate)

PL09

Perm Press

LCdE

(Wait 3-Seconds)

10

Location to be viewed/changed.

Press “Perm Press” key.

Display will read “LCdE,” left coin denomination for 3-seconds and the left coin acceptor denomination programmed (I.E. 25¢). If no change, press “Perm Press” key, otherwise press “HI” or “LO” keys and then “Perm Press” key.

Amount Increase

HI Temp

("Hold In" to Accelerate)

Perm Press

PL10

Proceed to next location

to be changed

To exit program mode, open program switch

Summary: The left coin denomination is programmable from 1 to 9999.

IMPORTANT: When the dryer is equipped with a dual coin acceptor, the value set here is the lower value denomination, which is not necessarily the left coin portion of the acceptor.

NOTE: For single coin models this parameter must be set for the value of the acceptor. I.E. 25¢ acceptor = 25.

43