12
C. FREE DRY MODE
1 When turning on power or when no cycle is in progress, the light emitting diode (L.E.D.) display will read
“FILL” and/or “FrEE.”
2. Select temperature. The dryer will start, the L.E.D. display will read the temperature cycle selected and
the drying time portion of the L.E.D. display will read the temperature cycle selected. The drying time
portion of the L.E.D. drying will read “00” and count upward as time elapses, or the vended time will count
downward, depending on which parameter is programmed.
NOTE: If the door is opened during a cycle, both the heat and motor will stop. However, the Phase 5
coin microprocessor controller (computer) will continue to count the time, either upward or
downward, depending on which parameter is programmed. Continuation of the cycle will
resume only after the door has been closed and any one (1) of three (3) temperature selection
buttons is again depressed.
3. Once the preprogrammed percent dryness level and cool down period has been reached or maximum
automatic time has expired, whichever comes first, the tone (buzzer) will sound, and the L.E.D. display will
read “donE” for 5-seconds, at which time the dryer will shut off.
NOTE: If the Anti-Wrinkle Program is active (“Grd”), the L.E.D. display will remain reading “donE,”
and the Phase 5 coin microprocessor controller (computer) will proceed through the
Anti-Wrinkle Program until the maximum “Guard On Time” has expired or door is opened,
whichever comes first. The L.E.D. display will read “FILL” and/or “Amount To Start”
(“AtSt”).
NOTE: If the Anti-Wrinkle Program is not active (“nGrd”), the L.E.D. display will read “donE” until
the main door is opened, at which time the L.E.D. display will read “FILL” and/or “Amount To
Start.”